757106
14
Zoom out
Zoom in
Previous page
1/26
Next page
12 EN
EN
Revision 04/2018Copyright © 2018, Fast ČR, a. s.
Control and operation
4.4. Radio
Selecting amode
During operation, repeatedly press the MOD button
and select the radio mode.
Selecting abroadcast band width
MU: Press the BND button repeatedly to select the
desired band. RC: Press the BND button repeatedly to
select the desired band.
Automatic scanning and saving of stations
In the radio mode, with functions TA, AF & PTY turned off, press and hold button BND to
start scanning frequencies and check signal strength until tuning is complete (message
"SEARCH"). Stations with strong signals are then stored under preset digits 1 -6. The
device then goes through the stations stored in memory and plays them for ashort
period. During this process, press the AMS button again to exit this function.
Note: the automatic scan stores stations with an acceptable/quality reception.
In areas with poor reception (e.g. also caused by an insufficient antenna) it is possible
that it will not store any stations. In such acase, improve reception using abetter quality
antenna.
Manual scanning and storing stations
You may store the tuned station (searched with
EN
buttons) in memory under
numbers 1–6 by pressing and holding down buttons 1 to 6. The number that you are
selecting flashes when held down. When it is lit permanently, the station has been stored.
Manual scanning upwards / downwards
To activate manual scan, press and hold the
EN
button, and the words "MANUAL
SCAN“ will briefly appear on the LCD display. During the manual scanning process,
repeatedly press the
EN
buttons to tune afrequency upwards or downwards to
the desired frequency. When the manual scan is not active for 5 seconds, the automatic
scanning mode will again be set.
Memory presets
Each band (FM1-3, AM1-2), selected using the BND button has 6 preset positions.
In the radio mode, press one of the numbers 1–6 to select astation that was stored in
memory.
Automatic scanning up / down
In the radio mode and when the TA, AF & PTY functions are off, press the
EN
buttons to scan frequencies up / down for the next strong signal.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sencor SCT 9411BMR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sencor SCT 9411BMR in the language / languages: English as an attachment in your email.

The manual is 2,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info