688542
8
Zoom out
Zoom in
Previous page
1/10
Next page
EN-8
EN
Coffeemaker
SCE 3050SS / SCE 3051RD
Revision 05/2016
Copyright © 2016, Fast ČR, a.s.
OPERATING THE COFFEEMAKER
1. Open the lid A1 and fill the water tank A3 with the required amount of water. The water level
must at least cover the mark showing two water cups and must not go over the maximum mark
showing 10 water cups (i.e. 1.25 l).
Attention:
Only fill the water tank with cold drinking water. Do not use hot water.
The water tank has a maximum capacity of 1.25 litres of water.
The amount of brewed coffee will always be less than the amount of water you poured into
the water tank A3. During the coffee brewing process, approximately 10 % of the water is
absorbed by the ground coffee.
2. Place the permanent filter A7 or a disposable paper filter size no. 4 into the filter holder A8.
3. Pour ground coffee into the filter. Recommended dosage: 7 g of ground coffee per cup. Set the hot
water arm A2 so that it points above the filter.
Note:
If you wish to brew tea, pour the required amount of tea into the filter.
4. Shut the lid A1 and make sure that it is properly closed.
5. Place the glass kettle with the lid Aqs on to the hotplate Aqd and start the coffeemaker by setting
switch Aqf to position I (On). The red indicator light will be lit.
6. Once the entire batch of coffee has finished brewing, wait approximately 1 minute for the drip
process to complete fully. Now the coffee can be served.
7. If you wish to serve the coffee later, leave the kettle Aqs on the hotplate Aqd. The hotplate Aqd will
keep the coffee at an optimal serving temperature. The coffeemaker will automatically turn itself
off after 40 minutes of operation.
8. Once you empty the kettle, return it back on to the hotplate Aqd and turn off the coffeemaker by
setting switch Aqf to position 0 (Off). The red indicator light will turn off.
9. Allow the coffeemaker to cool down for at least 10 minutes before using it again.
Warning:
If you do not allow the coffeemaker to cool down, the water could overheat and result in
subsequent scalding by the escaping steam.
10. Before using the coffeemaker again, remove the coffee grounds and wash the permanent filter
A7 or remove the paper filter together with the coffee grounds and dispose of it together with
normal household waste. Rinse the filter holder A8 and the kettle Aqs with clean water. Dry it and
put it back in its place.
11. When not using the coffeemaker, turn it off and disconnect it from the power socket.
DRIP-STOP FUNCTION
The Drip-Stop function will allow you to serve coffee before the end of the drip process.
1. Once at least half the amount of coffee is brewed, you may remove the kettle Aqs from the
coffeemaker. The Drip-Stop shut-off valve will be activated and coffee will stop dripping.
2. Serve the required amount of coffee and place the kettle Aqs back on the hotplate Aqd within
approximately 1 minute of taking it off to avoid the filter from overfilling with hot water.
3. When the kettle Aqd is placed back under the brew chamber A9, the drip process will resume
automatically.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sencor SCE 3050SS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sencor SCE 3050SS in the language / languages: English as an attachment in your email.

The manual is 0,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info