528671
7
Zoom out
Zoom in
Previous page
1/16
Next page
Measurement using Flash Unit with Synchro Cord
It is recommended that the meter is used in the wired measurement mode when
the flash light is measured from subject position or when the meter fails to register
flash light from wireless measurement; for example, close to a fluorescent lamp, or
in high ambient conditions etc.
1. Set the mode selection switch to position
The symbol
will be indicated on
the display (Fig. 10).
2. Set the film speed (ISO) and shutter speed
(r)
as shown in the paragraph for "Preparing the
Meter for Operation".
3. Connect the synchro cord to the synchro
terminal of meter and to the flash unit.
4. Press the measuring switch to fire the flash. The
appropriate F-stop value is displayed on the
meter. Press the measuring switch again for
repeat measurements (Fig. 11).
Note: The notes for wireless measurement
are also applicable to wired
measurement.
6
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sekonic L-328 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sekonic L-328 in the language / languages: English as an attachment in your email.

The manual is 1,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info