462276

Seiko SAT500 CHROMATIC TUNER Manual

2
Zoom out
Zoom in
Previous page
1/4
Next page
Input jack
When tuning an electric/electronic instument, connect the output cord of the instrument
to the input jack
. While the cord is connected to the input jack , the built-in
microphone
will not work.
Output jack
● Bypass function
The tuner outputs the signal input from the instrument connected with the input jack
to an amplifier and other devices through the output jack .
● Precautions on using the bypass function
1. Before connecting an amplifier to the output jack , be sure to set its volume control
to the lowest level, and turn it off, to prevent any malfunction of the tuner and the
amplifier. After checking that both the tuner and amplifier are turned off, properly
connect the amplifier to the output jack
of the tuner.
2. Turn on the tuner first, and then turn on the amplifier.
3. Even if the volume control is set at the lowest level, noise may be heard when they
are turned on. This is not a malfunction.
Built-in microphone
Use it to tune acoustic instruments.
● Precautions on using the microphone:
When tuning, bring the instrument as close as possible to the microphone. Make sure
that no cord is connected to the input jack
.
Built-in speaker
In SOUND mode, it gives out the reference note you have selected.
Slit stand
Insert a card or coin into the slit on the rear of the tuner to prop it up.
Strap hole
Use the hole to attach a strap to the tuner.
Caution:
Do not apply undue force to the tuner by swinging it with the strap or pulling the strap
forcibly, as this may cause damage to the tuner or injuries.
Caution:
Do not forcibly insert a card or
coin that will not fit into the slit,
as this may cause damage to the
tuner or injuries. Also, note that
the card or coin used to prop up
the tuner may get scratched or
damaged accidentally.
TUNER SETTING
Press the selector , UP and DOWN buttons to set the tuner as desired.
● Selection of the setting item:
With each press of the selector button , the setting item is selected in the following
order:
● Setting of items:
Press UP or DOWN button to set the selected setting item.
The two buttons change the setting of the selected item in the opposite order. In setting
the reference pitch, UP
and DOWN buttons increases and decreases the pitch
value, respectively. In setting the reference pitch, note, and key, the settings change
continuously by keeping the respective buttons pressed.
● Flashing of the indication and registration of the setting:
The flashing indication shows that the setting procedure is still in process. By pressing
the selector button
to select another setting item, the current setting is registered. If
the tuner is left untouched with the indication flashing, the flashing stops, and the setting
is automatically registered in a certain period of time.
■ Mode setting
MODE
+
Select the tuning mode.
AUTO mode : By inputting a note of the instrument, the tuner automatically
identifies and indicates the note having the pitch closest to it. It also
indicates that the pitch of the input note is lower or higher than that
of the indicated note.
MANUAL mode : Set the note you wish to tune, and then input a note. The tuner
indicates that the pitch of the input note is lower or higher than that
of the note you have set.
SOUND mode : The tuner gives out the note you have set. Tune the instrument on
the basis of the reference note the tuner produces.
■ Reference pitch setting
PITCH
+
Set the reference pitch (frequency of A4).
Settable range : 415 Hz and 435 ~ 446 Hz at 1 Hz steps
■ Note setting (for MANUAL and SOUND modes)
NOTE
+
Set the note you wish to tune.
In AUTO mode, the tuner automatically identifies the name of the input note, and the note
you have set will be disregarded.
● Settable range
AUTO mode : Not applicable.
MANUAL mode : C ~ B (at one-semitone steps, when the key is set at “C”)
SOUND mode : C4 ~ B4 (at one-semitone steps, when the key is set at “C”)
■ Key setting +
Set the key for the transposition tuning.
Selectable keys : E
, F, B , C
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Seiko SAT500 CHROMATIC TUNER at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Seiko SAT500 CHROMATIC TUNER in the language / languages: English as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info