606281
118
Zoom out
Zoom in
Previous page
1/148
Next page
116
Service Procedures (cont.)
Remove the InfoKey Controller Dock
Tool Required: 3 mm hex wrench, torque wrench with 3 mm bit
To remove the InfoKey Controller Dock:
1. Make sure the Segway PT is unplugged and powered off.
2. Using a 3 mm hex wrench, remove the fastener holding the InfoKey
Controller Dock to the LeanSteer Frame.
3. Remove the InfoKey Controller Dock.
Install/Remove the Dock Adapter
Tool Required: None
To install the InfoKey Controller Dock Adapter, screw the adapter to the
underside of the InfoKey Controller. When installed properly, the Dock
Adapter should snap into place when screwed on.
To remove the InfoKey Controller Dock Adapter, unscrew the adapter from
the underside of the InfoKey Controller.
Figure 77: Remove the InfoKey Controller Dock
118


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Segway x2 SE Turf at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Segway x2 SE Turf in the language / languages: English as an attachment in your email.

The manual is 7,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info