606279
20
Zoom out
Zoom in
Previous page
1/148
Next page
18
Assembling Your Segway PT (cont.)
To Set Up your Segway PT, follow the procedures below in the order listed.
For the name and location of specific PT components, see "Segway PT
Components and Subsystems" (p. 27).
Prepare the LeanSteer Frame
Tool Required: None
The LeanSteer Frame is collapsed to its shortest length for shipping.
Assembly is required before adjusting the Handlebar height for the first time.
To extend and assemble the LeanSteer Frame:
1. Remove the Height Adjustment knob (see Figure 9, page 21) by
turning the knob counterclockwise.
2. Extend the upper bar of the LeanSteer Frame by sliding it up from
its storage position until the slot for the Height Adjustment fastener
is visible.
3. Reinstall the Height Adjustment knob by turning and tightening the
knob clockwise.
Attach the Handlebar
Tool Required: Torque wrench with 3 mm bit
To attach the Handlebar to the LeanSteer Frame:
1. Make sure the Segway PT is unplugged and powered off.
2. Align the Handlebar in place against the LeanSteer Frame using the
alignment guides.
Figure 4: Attach the Handlebar
Handlebar
Fasteners
Handlebar clamp
Alignment guide
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Segway i2 SE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Segway i2 SE in the language / languages: English as an attachment in your email.

The manual is 7,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info