696929
23
Zoom out
Zoom in
Previous page
1/558
Next page
21
EN
Problems
Recommendations
If the pressure
indicator has risen
but nothing is
escaping through the
vent during cooking:
This is normal for the first few minutes.
If this persists, run cold water into your sink and sub-
merge the bottom of your pressure cooker until the
pressure indicator (D) comes down.
Clean the operating valve (A) - Fig. 16 and the steam
release outlet - Fig. 17 and use a cotton bud to check
that the security valve ball can be pressed without
any problems - Fig. 18.
If steam leaks out
around the lid, and
the pressure indicator
is in the lowered
position, check:
The correct closure of the lid.
The position of the gasket.
The condition of the gasket; replace if necessary.
The cleanliness of the lid, the gasket and its housing
in the lid.
The condition of the edge of the pot.
If you are unable to
open the lid:
Check that the pressure indicator (D) is in the
lowered position.
Otherwise, depressurise, run cold water into your sink
and submerge the bottom of your pressure cooker
until the pressure indicator comes down.
Never interfere with the pressure indicator (D).
Turn the operating valve (A) to the position
If the food is not coo-
ked or is burned,
check:
The cooking time.
The power of the heat source.
The correct position of the operating valve (A).
The quantity of liquid.
If food has burnt in
your pressure cooker:
Fill the pot with water and soak for a while before
washing.
Never use bleach or chlorine-containing chemicals.
If one of the
overpressure safety
systems is triggered:
Turn off the heat source.
Let your pressure cooker cool down without moving
it. Wait for the pressure indicator to fall and open the
pressure cooker.
Check and clean the operating valve (A), the steam
release outlet, the safety valve and the gasket.
If the problem persists, have your pressure cooker
checked by a TEFAL Approved Service Centre.
If you notice the
appearance of
oxidation marks
inside the stainless
steel pot:
The use of high performance stainless steel does not
prevent the appearance of oxidation in extreme
cases. If you notice oxidation marks, remove them by
rubbing with an abrasive sponge before using your
pressure cooker again.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SEB ClipsoMinut Perfect at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SEB ClipsoMinut Perfect in the language / languages: All languages as an attachment in your email.

The manual is 18,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of SEB ClipsoMinut Perfect

SEB ClipsoMinut Perfect User Manual - German, Dutch - 42 pages

SEB ClipsoMinut Perfect User Manual - French - 23 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info