234 If and when
–Raise the bonnet.
–Move the loop 1 in the direction of the arrow and remove the
cover ⇒ Fig. 149.
–Remove connector ⇒ Fig. 150 2 by pulling outward.
–Remove the bulb by pulling it out and fitting the new one.
–Installation involves the above steps in reverse sequence.
–Fit the cover and close the strap. Make sure that the gasket sits
well on the casing cover during the operation.
–Check whether the new bulb is working.
Main beam headlights
Fig. 151 Main beam
headlights
Fig. 152 Main beam
headlights
–Raise the bonnet.
–Move the loop 1 in the direction of the arrow and remove the
cover ⇒ Fig. 151.
–Remove connector ⇒ Fig. 152 2 by pulling outward.
–Extract the bulb and fit the replacement so that it sits correctly
into the cut-out on the reflector.
–Installation involves the above steps in reverse sequence.
–Fit the cover and close the strap. Make sure that the gasket sits
well on the casing cover during the operation.
–Check whether the new bulb is working.
