94 Opening and closing
WARNING (Continued)
●The electric windows will work until the ignition has been switched
off and one of the front doors has been opened.
●If necessary, use the safety switch to disable the rear electric win-
dows. Make sure that they have been disabled.
Note
If the window is not able to close because it is stiff or because of an ob-
struction, the window will automatically open again ⇒ page 94. If this
happens, check why the window could not be closed before attempting to
close it again.
One-touch opening and closing*
One-touch opening and closing means you do not have to
hold down the button.
Buttons ⇒ Fig. 51 1, 2, 4 and 5 have two positions for open-
ing windows and two for closing them. This makes it easier to open
and close windows to the desired position.
One-touch closing
–Pull up the window button briefly up to the second position. The
window closes fully.
One-touch opening
–Push down the window button briefly up to the second position.
The window opens fully.
Restoring one-touch opening and closing
–The automatic open and close function will not work if the bat-
tery has been temporarily disconnected. The function can be re-
stored as follows:
–Close the window as far as it will go by lifting and holding the
electric window switch.
–Release the switch and then lift it again for one second. This
will re-enable the automatic function.
If you push (or pull) a button to the first stage, the window will open (or
close) until you release the button. If you push or lift the button briefly to
the second stage, the window will open (one-touch opening) or close (one-
touch closing) automatically. If you operate the button while the window is
opening or closing, it stops at this position.
The one-touch opening and closing function will not function once the igni-
tion has been switched off.
The one-touch function and roll-back function will not work if there is a mal-
function in the electric windows. Contact a specialised workshop.
Roll-back function
The roll-back function reduces the risk of injury when the
electric windows close.
●If a window is obstructed when closing automatically, the window stops
at this point and lowers immediately ⇒ .
●Next, check why the window does not close before attempting it again.
●If you try within the following 10 seconds and the window closes again
with difficulty or there is an obstruction, the automatic closing will stop
working for 10 seconds.
