282 If and when
Changing the turn signal bulb
The procedure for changing the bulb is the same on both
sides.
Fig. 219 Turn signal
Fig. 220 Turn signal
–Switch off the ignition and the lights.
–Raise the bonnet.
–Pull the rubber cap ⇒ Fig. 219 to remove it.
–Remove the bulb holder by pulling on the grip and turning it an-
ticlockwise ⇒ Fig. 220.
–Replace the blown bulb in the bulb holder (press and turn anti-
clockwise to remove) with a new bulb (press and turn clockwise
to insert).
–Insert the bulb holder into the socket with the tab facing up-
wards and the grip horizontal. Press it against the socket and
turn clockwise. When changing the bulb, you can check the po-
sition of the bulb through the headlight glass.
–Fit the rubber cap and tighten, making sure it fit properly into
the headlight casing.
–Check whether the new bulb is working.
Changing the xenon bulb
The procedure for changing the bulb is the same on both sides.
WARNING
This type of bulb should be changed at a specialised workshop.
