817399
330
Zoom out
Zoom in
Previous page
1/382
Next page
If and when328
Indicator
Several warning and indicator lamps should light up for a few seconds when
the ignition is switched on. This signals that the lamp is working properly.
They will switch off after a few seconds.
Checking the bulbs of a trailer
For vehicles with the factory fitted trailer system, certain trailer lights are also
controlled if the socket is correctly connected.
A fault on a trailer turn indicator is indicated on the instrument panel by the
indicator blinking twice as fast ( or ) page 99.
xGeneral fault of all indicators on one side.
xFault in one tail light (on some models, also the registration light).
xFault in two brake lights.
WARNING
If the warning lamps and messages are ignored, the vehicle may stall in
traffic, or may cause accidents and severe injuries.
xNever ignore the warning lamps or text messages.
xStop the vehicle safely as soon as possible.
Caution
Failure to heed the warning lamps and text messages when they appear may
result in faults in the vehicle.
Note
A fault in the LED on the tail lights will not be indicated. However, if the fault
affects all the LEDs then this will be indicated by the indicator .
Information for replacing bulbs
Checklist
To replace a bulb, carry out the following operations always in the order given
:
1. Park the vehicle a safe distance from traffic and on suitable ground.
2. Connect the electronic parking brake page 188.
3. Turn the light switch to position 0 page 99.
4. Move the gear lever into the neutral position page 99.
5. Automatic gearbox: Move selector lever to position P page 179.
6. Stop the engine and remove the key from the ignition page 175.
7. Manual gearbox: Select a gear page 179.
8. Wait until all of the passenger compartment lights are turned off
page 99.
9. Allow the corresponding bulb to cool.
10. Visually inspect fuses to see if any are blown page 323.
11. Replace the bulb according to the instructions . Bulbs should only
be replaced with new identical models. Bulb information is displayed on
the bulb socket or on the bulb itself.
12. In general, never touch the bulb glass directly. The heat of the bulb would
cause the fingerprint to evaporate and condense on the reflector. This
will impair the brightness of the headlight.
Lights up Possible cause Solution
A vehicle exterior lighting
bulb is not working. Replace the faulty bulb.
330


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Seat Alhambra 2010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Seat Alhambra 2010 in the language / languages: English as an attachment in your email.

The manual is 3.92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Seat Alhambra 2010

Seat Alhambra 2010 User Manual - German - 392 pages

Seat Alhambra 2010 User Manual - French - 402 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info