35
XII. Troubleshooting Guide
1. Digital Pro Flash does not fire when switch is turned from
“ON” to “TEST.”
a. Wait until the red flash-ready light turns on. If the ready
light does not turn on, make sure the battery polarity is
correct and battery contacts are clean.
b. Check the battery power. Replace or recharge batteries,
if necessary.
c. If above does not correct the problem, contact your local
SeaLife dealer or SeaLife Service Center in your country.
For a list of dealers, please visit www.sealife-cameras.com.
2. Digital Pro Flash fires as tested above, but does not fire when
triggered by camera.
a. Make sure the power switch is set to “ON” position and
the red flash-ready light is on.
b. Take a test pictures and make sure your camera’s inner
flash fires.
c. Check that your camera settings are correct.
i. For SeaLife digital cameras, set to External Flash
mode. Make sure camera’s ready-light is on.
ii. For other camera brands, set camera to Flash ON.
Make sure the camera’s flash setting is not set to
Auto or Red-Eye reduction. Refer to your camera
instructions for problems related to the camera.
d. Make sure the flash pre-flash setting switch is properly set in
accordance with the instructions provided in this manual.