779983
64
Zoom out
Zoom in
Previous page
1/158
Next page
ENGLISH ORIGINAL OPERATING INSTRUCTIONS 2021 | TREKKING AND TREKKING-PEDELEC
| 64
b ca
In the case of most suspension forks with coil springs a preload can be applied
to the springs within tight limits by turning a knob at the top of the fork crown
(a). If that is not possible and the desired negative suspension travel (“sag)
cannot be set, the coil springs must be replaced by harder or softer models. The
replacement is a job for the SCOTT dealer.
When replacing any parts, be sure to only use parts that bear the appropriate
mark and, to be on the safe side, original spare parts. Your SCOTT dealer will be
pleased to help you.
Always make a test ride over roads with various surfaces after each change to
the settings (b).
Check afterwards the position of the rubber ring/cable tie. Its distance from the
wiper is the maximum suspension travel that you have used (c). If the rubber
o-ring/cable tie has moved a few millimetres only, your rear shock is too firm.
Reduce the air pressure of air sprung forks or the initial spring tension of coil
springs. If that brings no improvement, have the springs replaced.
If the rubber ring/cable tie has shifted over the entire length of the tube or if
the fork audibly bottoms out and hits the top repeatedly when riding on bad
roads, the setting of the springs is too soft. In the case of air-suspension forks
the pressure must be increased. In the case of steel coils, have them replaced by
your SCOTT dealer.
WARNING
Suspension forks are designed in a way to absorb shocks. If the fork is too
rigid and jammed, the terrain-induced shocks pass directly into the frame
without any damping. The frame is normally not designed to withstand such
undamped stresses. If your suspension has a lockout mechanism, do not ac-
tivate the lockout function when riding in rough terrain, but only when riding
over smooth terrain (roads) and on field tracks.
The suspension fork should be set up and adjusted in a way that it does not
reach the end of its travel, i.e. bottom out, unless in extreme cases. A spring
rate which is too soft (air pressure is too low) can usually be heard or felt as
a “clunk” type noise. This noise is caused by the sudden complete compres-
sion of the suspension fork as it reaches bottom out. If the suspension fork
frequently reaches bottom out, it will fail over time, and so will the frame.
64


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scott Trekking E-Bike 2021 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scott Trekking E-Bike 2021 in the language / languages: English as an attachment in your email.

The manual is 28.73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Scott Trekking E-Bike 2021

Scott Trekking E-Bike 2021 User Manual - German - 163 pages

Scott Trekking E-Bike 2021 User Manual - French - 159 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info