779984
36
Zoom out
Zoom in
Previous page
1/120
Next page
ENGLISH OWNER’S MANUAL 2021 | ROAD BIKE
| 36
b ca
Align the saddle with the frame by using the saddle nose and the bottom brack-
et or top tube as a reference point. Clamp the seat post tight again by closing
the quick-release, as described in the chapter “Using quick-releases and thru
axles” or by turning the seat post binder bolts clockwise in half turns or better
in steps of 0.5Nm increments starting at 3Nm (a). You should not need much
strength in your hands to clamp the seat post sufficiently tight. Otherwise the
seat post does not match the frame.
Verify in between that the seat post is sufficiently tight by taking hold of the
saddle at both ends and then trying to rotate the seat post inside the seat tube
(b). If it does rotate, gently retighten the binder bolt of the seat post clamp by
half a turn or better by a quarter turn or in steps of 0.5Nm increments and do
the check again.
Does the leg stretch test now produce the correct result? Check by moving your
foot and pedal to the lowest point. When the ball of your foot is exactly above
the pedal centre in the ideal pedalling position, your knee should be slightly
bent. If this is the case, the saddle height is adjusted to the correct height.
Check whether you can touch the ground safely while sitting on the saddle by
stretching your feet to the floor (c). If not, you should lower the saddle until you
can, at least to begin with.
WARNING
Never apply grease or oil into a seat tube of a frame made of carbon un-
less an alloy sleeve is inside the frame. If you mount a carbon seat post, do
not put any grease on it, even if the frame is made of metal. Once greased,
carbon components may never again ensure reliable clamping! Use special
carbon assembly paste instead.
Never ride your bike with the seat post drawn out beyond the limit, maxi-
mum, or stop mark! The seat post might break or cause severe damage to
the frame. Please make sure the seat post clamp is correctly orientated with
the seat post frame clamping slot in the seat tube of the frame. In the case
of frames with seat tubes that extend beyond the top of the frame’s top tube
the seat post should be inserted into the seat tube at least below the bottom
of the top tube and below the top of the rear stays! If seat post and frame
require different minimum insertion depths, you should opt for the deeper
insertion depth.
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scott Road Bikes - 2021 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scott Road Bikes - 2021 in the language / languages: English as an attachment in your email.

The manual is 26.68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Scott Road Bikes - 2021

Scott Road Bikes - 2021 User Manual - German - 125 pages

Scott Road Bikes - 2021 User Manual - French - 121 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info