168203
11
Zoom out
Zoom in
Previous page
1/50
Next page
Many vehicles are pre-fitted with ISO connectors behind the dashboard, including all the electrical cabling for a car radio. In such cases, the
connections fitted to the vehicle can be directly plugged into the car radio connectors. Should your car not be pre-fitted with these connectors,
we strongly advise you to obtain the ISO wiring loom fitted with the male connector for connection to your car radio either from a specialist
shop or from the car dealer for your vehicle. Once obtained, you will only need to connect your loudspeakers and the power supply to the ISO
connector, following the connection instructions below.
Power Supply Connector
1.Battery (yellow)
Speaker Connector
Power Supply Connector
5. Speaker Connector 10.Front left speaker + (white)
6.Rear right speaker + (violet) 11.Front left speaker – (white/black)
2.Ground (black) 7.Rear right speaker - (violet/black) 12.Rear left speaker + (green)
3.Power +12 volt (red) 8.Front right speaker + (grey)
13.Rear left speaker – (green/black)
4. Electrical Antenna (blue)
9.Front right speaker – (grey/black)
1) Make sure your car battery is a 12 volt (6 filter caps) negative ground system (if not, a converter will be necessary).
2) Before starting wiring connections, disconnect the power supply by removing the fuse from the fuse holder.
3) Connect the power wire to one of the extra terminal of the car.
4) Connect the black ground wire to a metal part of the car. It is important to make good contact.
5) Make other wiring connections as shown.
6) Connect the battery of the car.
7) Replace the fuse holder of the unit.
NOTE IN CORRECT WIRING OR OPERATION WILL VOID THE WARRANTY OF THIS UNIT.
GB-10
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scott drx 600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scott drx 600 in the language / languages: English as an attachment in your email.

The manual is 2,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info