817109

Schwaiger LED220 Manual

7
Zoom out
Zoom in
Previous page
1/24
Next page
USER MANUAL LED220 011
7
Remove the screw on the battery compartment cover (Fig. 4). With
your fi ngertip, pull up on the battery compartment catch and pull out-
ward to remove the battery compartment cover (Fig. 5).
Insert 3 new alkaline C cell batteries (not included) into the battery
compartment and orient them with the‘+‘ and markings on the back of
the battery compartment (Fig. 6). Re-attach the battery compartment
cover by aligning the legs on the lower edge of the battery compart-
ment cover onto the fi xture body and close the cover until the catch at
the top engages. Replace the screw. Do not mix old and new batteries.
Cold weather may have a negative impact on battery life.
Attach the led lamp to the rear housing cover by positioning the led
lamp over the rear housing cover at an angle. Engage the led lamp into
the grooves of the rear housing cover and secure by twisting clockwise
until the led lamp is seated vertically (Fig. 7).
OPERATING INSTRUCTIONS
The individual light heads can be adjusted side to side and up/down
independently to aim the light heads in the direction desired (Fig. 1).
The motion sensor can be rotated to position in the direction of an area
to be covered. If the 2 tick marks are aligned, the motion sensor is
focused straight ahead. The motion sensor can be rotated approxima-
tely 45 degrees right or left of center (Fig. 2). The motion sensor has
a maximum detection fi eld of 130° at a distance of 30 ft.
The control knobs for adjusting
the operation of the led lamp
(TIME, SENS and LUX) are
located on the back side of the
motion sensor. To gain access
to these controls, rotate the
sensor clock-wise until they are
in view (Fig. 3).
The TIME control knob can be adjusted to control the length of time
the light stays ON when triggered by the PIR sensor (Fig. 4). In the far
left position (-), the duration time is approximately 10 seconds. In the
far right position (+) the duration time is approximately 30 seconds.
The SENS control knob can be adjusted to control the range of the PIR
sensor (Fig. 5). The far left position (-) sets the PIR sensor range to
approximately 1 foot. The far right (+) sets the PIR range to appro-
ximately 30 feet.
The LUX control knob can be adjusted for the surrounding level of dar-
kness needed to activate the PIR (Fig. 6). This is quite variable. The far
left position (-) sets for minimum level of darkness. The far right posi-
tion (+) sets for a maximum level of darkness (or near full darkness).
4
12
3
4 5 6
5
6
7
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Schwaiger LED220 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Schwaiger LED220 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1.22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info