331269

Scholtes tt 6244 Manual

20
Zoom out
Zoom in
Previous page
1/60
Next page
20
GB
Programming the cooking time
! All the cooking zones may be programmed for a
length of time between 1 and 99 minutes.
1. Switch the hotplate on and set the temperature.
2. Press the button repeatedly until the light
corresponding to the plate you wish to use illuminates.
3. Set the cooking time using the
and
buttons.
4. Confirm by pressing the
button.
The timer begins counting down immediately. When
the set programme has finished, a buzzer sounds for
about 10 seconds and the cooking zone switches off.
Repeat the above procedure for each hotplate you
wish to programme.
Using multiple programmes and the display
If one or more plates are programmed, the display will
show the data for the plate with the least time
remaining, and the light corresponding to the position
of the plate will be switched on. The lights
corresponding to the other plates programmed will
flash.
To display the time remaining for the other
programmed plates, press the
button repeatedly.
The times remaining for each plate will be shown in a
clockwise order, beginning with the front left plate.
Changing the programme
1. Press the
button repeatedly until the time you
wish to change is shown.
2. Use the
buttons to set the new time.
3. Confirm by pressing the
button.
To cancel a programme, follow the above points.
When it comes to point 2, press the
buttons
simultaneously. The setting will return to zero and the
display will no longer be operating in the programme
set function.
Control panel lock
When the hob is switched on, it is possible to lock the
oven controls to avoid accidental changes to the
settings (by children, during cleaning, etc.). Press the
button to lock the control panel: the indicator light
above the button will switch on.
To use any of the controls (e.g. to stop cooking), you
must switch off this function. Press the
button for a
few moments, the indicator light will switch off and the
lock function will be removed.
Switching off the hob
Press the
button to switch the appliance off.
If the control panel lock is on, the controls will
continue to be locked even after the hob is switched
on again. In order to switch the hob on again, you
must first remove the lock function.
Demo mode
It is possible to set the hob to a demonstration mode
where all the controls work normally but the heating
elements do not switch on. To activate the demo
mode the hob must be switched on, with the control
panel lock activated.
Press the
button for the rear left plate, the
button for the front right plate and the button
simultaneously and hold them for three seconds.
The display will alternate between DE and MO and
the hob will be switched off.
When the hob is switched on again it will be set to
the demo mode.
To cancel this function:
When the hob is switched on and the control panel
lock is on, press the buttons as instructed above.
The display will alternate between RE and AL and
the hob will be switched off.
When it is next switched on, the hob will function
normally.
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scholtes tt 6244 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scholtes tt 6244 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info