Manual Scholtes TG640 (page 19 of 52) (English, Dutch, French, Italian)

495403

Zoom out

Zoom in

1/52

 The position of the corresponding gas burner or

electric hotplate* is shown on every knob.

Gas burners

Each burner can be adjusted to one of the following

settings using the corresponding control knob:

 Off

Maximum

Minimum

To light one of the burners, hold a lit match or lighter

near the burner and, at the same time, press down

and turn the corresponding knob anti-clockwise to the

maximum setting.

Since the burner is fitted with a safety device, the

knob should be pressed for approximately 2-3

seconds to allow the automatic device keeping the

flame alight to heat up.

When using models with an ignition button, light the

desired burner pressing down the corresponding

knob as far as possible and turning it anticlockwise

towards the maximum setting.

 If a flame is accidentally extinguished, turn off the

control knob and wait for at least 1 minute before

trying to relight it.

To switch off the burner, turn the knob in a clockwise

direction until it stops (when reaches the  position).

The "double-flame" burner*

This gas burner consists of two concentric flame

rings. Using both flame rings enables a higher

power level to be reached, thus reducing cooking

time with respect to the time required by traditional

burners. The double ring also enables heat to be

distributed across the base of the pan more evenly.

Cookware of all sizes may be used; when cooking

with small recipients use only the inner burner. The

burner is controlled with a single knob.

To light it, press the knob in fully and turn it in an

anticlockwise direction until it reaches the maximum

position

. The burner is equipped with an

electronic lighting system that is activated

automatically when the knob is pressed.

As the burner is fitted with a safety device, the

knob should be held down for approximately 2-3

seconds, until the automatic device keeping the

flame alight has heated up.

Each burner can be adjusted using the control knob

as follows:

 Off

On and inner ring set to maximum

Inner ring set to minimum

Both rings set to maximum

Both rings set to minimum

To switch off the burner, turn the knob in a clockwise

direction until it stops (when it reaches the 

position).

Ceramic Glass

Module*

This cooktop is fitted

with dual-ring radiant

heating elements

located beneath the

glass. It is possible to

turn on only the circular

part of the elemement

(identified by the letter

"A") or the cooking

surface can be

enlarged by turning on

both "A" and "B". To

turn only the circular "A" element, simply turn the

knob in the clockwise direction to any one of the 12

available settings. To add the "B" section, turn the

knob to setting 12 and then click it into the

setting. Then proceed by turning the knob in the

counter-clockwise direction to one of the 12

settings.

The figure shows the heating zones, which become

red when the element is turned on.

A. Circular heating zone;

B.Extended heating zone;

C.Indicator light to show when the cooking zone is

above 60°C, even after the heating element has

been turned off.

When the knob is on any of the settings other than

"Off", the Indicator Light for Ceramic Glass Module

comes on.

Start-up and use

Only available on certain models.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Scholtes TG640 in the language / languages: English, Dutch, French, Italian as an attachment in your email.

The manual is 1,66 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Scholtes TG640 Manual

Product: