Manual Scholtes pp 30tc120 (page 14 of 76) (English, German, Dutch, French, Italian, Spanish)

331465

Zoom out

Zoom in

1/76

Securing the appliance to the cabinet

There are three different groups of appliance as far as

installation is concerned:

1-Built-in hobs flush with the worktop (Class 3 - see figure

2, detail H1). In this case it is necessary to make a hole

with measurements matching those of the hob in the

worktop. The measurement at the side should be reduced

by 2 cm so as to ensure that 1 cm of the hob overlaps with

and rests on top of the supporting surface (see figure 3). To

fit the hob flush with the worktop, it is necessary to cut

lower on this supporting surface (see figure 3 and 4), so

that both the edge of the hob and the seal under it can be

positioned there.

Before fitting the hob to the worktop, position the seal

provided along the perimeter of the hob, as illustrated in fi-

gure 4.

Brackets for fixing hobs to the cabinet have been provided,

and these should be fitted as shown in detail S.

2-Built-in hobs (Class 3) with edges lower than 58 mm (see

figure 2, detail H2). To install this type of hob, a hole large

enough to accommodate the whole lower casing of the

appliance must be made on the worktop intended to be

under the hob. Remember to leave a gap of at least 1 cm

between the lower casing and the worktop around the

whole perimeter of the appliance (the underside of the

casing can, however, touch the surface below it). To fit the

appliances, follow the instructions given above in point 1 or

use any supplementary instruction leaflet that is provided

in special cases.

BUILT-IN HOB

HEIGHT= STEEL THICKNESS

BUILT-IN HOB

STEEL TICKNESS <HEIGHT <58mm

SIT ON - ON HOB

HEIGHT >58mm

fig.2

fig 3

TOP

10mm

2,5mm

Y+2mm

X+2mm

R 11mm

X-20mm

Y-20mm

360 mm

1160 mm

345 mm

1145 mm

For model PP 30TC 120:

3-Sit-on hobs (Class 1) with edges higher than 58 mm (see

figure 2, detail H3). In this case, the lower casing of the

hob does not protrude further than the edge of the

appliance. Even when the hob is resting on the worktop, it

will suffice to leave space for the gas supply tube and

electricity supply cable. To fit this type of hob, follow the

instructions below (fig. 5):

• Fix the two screws provided "A" at a distance from the

back panel as shown in figure 7, leaving the heads of the

screws sticking out of the wood by 1.5 mm.

• Hook the hob onto the two screws "A" and push it

towards the back.

fig.4

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Scholtes pp 30tc120 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 6,44 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Scholtes pp 30tc120 Manual

Product: