128413

Scholtes hp 97 Manual

14
Zoom out
Zoom in
Previous page
1/48
Next page
14
GB
A
B
Operation e Maintenence
Operation
To start the hood (after following all the instructions
described in the previous paragraphs for the
installation and having taken all the safety
precautions), check which type of controls - among
the 2 types indicated below - your hood is provided
with and then follow the relevant directions given.
Push-button controls
The control panel includes:
· 1 “I\0” button to turn the motor on/off
· 3 “I” “II” “III”, buttons to adjust the motor speed
(1st - 2nd - 3rd speed)
·1 “
” button to turn the lighting on/off
Touch controls
The control panel includes:
·1 “
“ key to turn the motor on/
off
·1 “
“ key to reduce the motor
speed
·1 “
“ key to increase the
motor speed
·1 “
“ display that indicates the
motor speed
·1 “
“ key which, once
pressed, turns the motor off
after approximately 12 mins -
when the function is enabled, a
“
“ dot turns on at the bottom
right-hand side of the “
“
display.
·1 “
“ key to turn the lighting
on/off
ATTENTION:
Every 30 hours of use the microprocessor, which is
the heart of the system, indicates with a flashing “A”
on the display that the metal grease filters should be
cleaned to consent the exhaust to function better and
improve hygiene in the room. To cancel the warning
message after cleaning the filters, switch off the
hood, press and hold key n°2 for more than 5
seconds. When the key is pressed the letter “A”
appears on the display; after 5 seconds this
disappears and the microprocessor starts a new 30-
hour count-down before displaying the next warning
message.
Maintenance
Always make sure you carry out all operations with
the omnipolar switch off, in position O.
A) Cleaning
Clean the external parts of the hood using a soft
cloth and neutral detergent; and avoid using abrasive
powders or brushes. For dirt which is difficult to
remove, you may use methylated spirit. Clean the
steel parts by rubbing in the direction of the surface
finish.
B) Cleaning the Metal Grease Filter
Excess grease particles in the metal filter could
cause an increase in the inflammability of the same;
in order to avoid possible fires, the metal grease filter
should be washed according to how frequently it is
used (in any case every 30 days) in a dishwasher or
in lukewarm water using normal washing up liquid.
After rinsing it and drying it thoroughly, replace the
metal grease filter in its special housing.
C) Lamp Replacement
The hood can be provided with different types of
lamps: incandescent, halogen and neon lamps.
· Halogen lamps (fig. 5 and fig. 6): Figure 5
illustrates the type of lamp with a G4 cap, 20W
power and 12V voltage; to replace it, use a
screwdriver to remove the glass support ring “A”
(fig. 6), then remove the protection glass “B”; pull
out the faulty lamp and replace it with a new one;
then reassemble the protection glass, fastening it
with the corresponding ring.
Fig. 5
Fig. 6
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scholtes hp 97 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scholtes hp 97 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info