782293

Scheppach SX8 Woodster Manual

15
Zoom out
Zoom in
Previous page
1/102
Next page
15
Do not cut:
• Ferrousmaterials,steelandcastironoranyothermate-
rialnotmentionedaboveandinparticularfoodstuffs;
• Circularsawwithoutprotection.
Start-up
Observe the safety notes in the operating instructions before
operating the machine.
REMOVAL OF PACKAGING
Removetheboxusedtoprotectthemachineduringtrans
portion and keep it intact for future transportation and
storage.
DISPLACEMENT
As the undercut mitre saw is relatively small and light, it
canbeeasilytransportedevenbyoneperson.Itissuf-
cient to lift the saw by the handle after the locking button
(13)hasbeenlockedinthelowestposition.
TRANSPORT
Incasethemachineneedstobetransportedputitinthe
originalpackinginwhichitwasdelivered.Seetoitthatit
isplacedinthecorrectposition(regardsignsonbox).
Ifpossiblesecuretheboxwithstrapstoavoidunintended
movementorlossofpartsofthemachine.
POSITION/WORK STATION
Placethemachineonaworkbenchoronasufcientlyat
base/pedestaltoensurethebestpossiblestability.
Bearinginmindergonomiccriteria,theidealheightofthe
bench or of the base should be such that the base surface
ortheupperworksurfaceisbetween90and95cm.from
the ground.
Always ensure that there is at least 80 cm. of manoeu-
vring space in all directions around the machine in or-
dertoperformallnecessarycleaning,maintenanceand
adjustmentoperationssafelywithasufcientamountof
spaceavailable.
CAUTION: Ensurethemachineisplacedinasuitableposi-
tion both in terms of environmental conditions and light-
ing.
Always bear in mind that general environmental conditions
areoffundamentalimportancetopreventaccidents.
ELECTRICAL CONNECTIONS
Check that the electrical system to which the machine is
connected is earthed in compliance with current safety
regulationsandthatthecurrentsocketisinperfectcon-
dition.
Theelectricalsystemmustbettedwithamagnetother-
mal protective device to safeguard all conductors from
short circuits and overload.
The selection of this device should be in line with the
followingelectricalspecicationsofthemachinestated
on the motor.
NOTE: Your mitresaw’s electrical system is equipped
La machine ne convient pas pour la coupe de:
• Materiaux ferreux, aciers et fontes et pour tout autre
materiaunonenumeredansl’usageconsentietenpar-
ticulierpourlessubstancesalimentaires.
• Sciecirculairesansprotection.
Mise en route
Attention: Avant la mise en route, consultez les consignes
de sécurité.
DEBALLAGE
Enlevezlaboîtequiprotègelamachinedurantletrans-
port,enprenantsoindelamaintenirintactepourlecas
oùvousdevriezdéplacerlatronçonneusesurdelongstra-
jets ou l’emmagasiner à long terme.
DEPLACEMENT
Commelascieàongletsestrelativementpetiteetlégère,
ellepeutêtrefacilementdéplacéemêmeparuneseule
personne.D’abord,ilfautserrerleboutondeblocage(13)
danssapositionlaplusbasse.Ensuiteenleverlasciepar
la manette.
TRANSPORT
S’ilfauttransporterlamachine,lareplacerdanssaboîte
d’origine -qui la contenait au moment de l’achat- et res-
pecterlesèchesdel’emballageaumomentdel’insertion
pourretrouverlabonneposition.
Contrôlerlespictogrammesimpriméssurlaboîtecarils
fournissentlesindicationspourlamisesurpaletteetpour
lasuperpositiondeplusieursboîtes.
Danslamesuredupossiblenousconseillonsdexerle
chargementavecdescordesoudescourroiesdesécurité
pour éviter des glissements et des chutes de la charge
durantletransport.
POSITIONNEMENT/POSTE DU TRAVAIL
Placezlamachinesurunbancoubiensurunsocle/pié-
destalsufsammentplat,demanièreàavoirlameilleure
stabilitépossible.
Poureffectuerlestraitementsentenantcomptedescritè-
resergonomiques,lahauteuridéaledubancoudusocle
doitêtrecellequivouspermetdepositionnerleplande
labase,oubienleplandetravailsupérieur,àunehauteur
compriseentre90et95cmdusol.
Lepositionnementsurlepostedetravaildoitêtreétudié
demanièreàdisposerde80cmauminimumd’espace
toutautourdelamachine,danstouteslesdirections,pour
pouvoirtravailleravecsécuritéeteffectuerlenettoyage,
lamaintenanceetlesréglagesnécessaires.
PRUDENCE: Prendresoindepositionnerlamachinedans
unezonedetravailappropriéesoitdupointdevuedes
conditionsambiantes,soitdupointdevuedelalumino-
sité; ne jamais oublier que les conditions générales du
milieudetravailsontfondamentalesdanslaprévention
des accidents.
CONNEXION ELECTRIQUE
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach SX8 Woodster at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach SX8 Woodster in the language / languages: All languages as an attachment in your email.

The manual is 2.96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info