781618
24
Zoom out
Zoom in
Previous page
1/120
Next page
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
24 | GB
8. Operation
8.1 Starting the engine (Fig. 4 - 5)
Attention! This generator can only be started when
the battery is connected!
Fuel tap switch (8) on position “ON” (Fig. 4)
Set the start, stop switch (10) to the RUN (I)“ po-
sition.
You now have three options for starting the gen-
erator.
- Set the start, stop switch to the Start (II) posi-
tion.
- Use the enclosed remote control (D) to start the
generator, to do so, press the “ON” button.
- Use the recoil starter (6) to start the engine; to
do so, pull the handle forcefully. Move the recoil
started back to the original position carefully
and slowly. If the engine does not start, pull on
the handle again.
8.2 Switching off the engine
Let the generator run briey without load before
you turn it off, so that the aggregate can “recooling”
Press the OFFbutton on the remote control (D) or
set the start, stop switch to the STOP position (O).
Move the Fuel tap switch to position “OFF”.
Indicator lights
Oil warning light (A)
Display is active at low oil level and deactivated when
sufcient oil level.
Overload indicator (B)
Overload protection is active at too high a power
take-off - Turns off 230 V sockets (16).
Turn off the unit (see section 8.2).
Connected devices from separate generator. The unit
(see section 8.1).
Operating display (C)
Power indicator active - when the engine is running.
8.3 Energy saving switch (9)
If the energy saving switch is switched to the “ON(
) position, the engine runs automatically at idle
unless a consumer is connected. If a consumer is
connected, the engine returns to its full speed. This
setting is recommended to minimise the fuel con-
sumption.
Attention!
Set the energy saving switch (9) to the “OFF” position
() if a high power device is connected or if several
devices are connected. Then wait until the genera-
tor has absorbed the load, switch the energy saving
switch on as required.
Attention! This generator can only be started when
the battery is connected!
Attention! Fill the oil before rst use.
Before each use, check the oil level with the engine
switched off and on a level surface. Use the highest
quality four-stroke oil or an HD oil with the same level
of quality.
SAE 10W30 / 15W40 is recommended for general
use at all temperatures.
Connecting the battery
Release the battery compartment cover by undo-
ing the two screws using the enclosed Phillips head
screwdriver. Now connect the red cable to the plus
pole (+) and the black cable to the minus pole (-).
Note: The battery charges itself during operation.
Checking the oil level, g. 6 - 7
Remove the cover (6) (Fig. 6)
Unscrew the dipstick and clean it.
Check the oil level by inserting the dipstick into the
lling nozzle without screwing the cap on.
If the oil level is too low, rell with the recommended oil.
The oil level must be between min. and max. (Fig. 7)
Filling with fuel
To refuel - cap (4) open counter clockwise.
Fill fuel tank in
Closing tank - tank cap (4) clockwise.
Recommended fuel
Unleaded regular gasoline with a research octane
number of 91 or higher is required for this engine.
Use only fresh and clean fuel.
m Water or impurities in the petrol damage the fuel
system.
Tank volume: 7,4 litre
m Refuel in a well-ventilated area with the
stopped engine. If the engine has been running,
allow it to cool rst. Never refuel the engine in-
side a building where gasoline fumes may reach
ames or sparks.
Petrol is highly ammable and explosiv. You can
get burns or other serious injuries when handling
fuel.
Switch off the engine and keep it away from heat,
sparks and ames.
Refuelling only outdoors.
Immediately clean up spilled petrol.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach SG3400i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach SG3400i in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 11.37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info