781925

Scheppach SG2600 Manual

51
Zoom out
Zoom in
Previous page
1/148
Next page
51
WARNING: Do not use any pipes that carry inam-
mable substances as an earth source.
Start the engine (g. 5)
NOTE: Do not connect the electrical device before
starting the engine.
1 Turn the fuel valve (B) to 1.
When the engine is cold:
Turn the choke lever (C) to the CLOSED position.
When the engine is warm:
Turn the choke lever to OPEN
2 Turn the engine switch to the ON position.
3 Pull the recoil starter slowly until resistance is notice-
able. Then pull hard.
4 Return the choke lever to the OPEN position while
the engine warms up.
WARNING: Ensure that you do not injure your n-
gers. If the motor does not start and a piston was
not raised completely, the starter grip may sud-
denly spring back to the engine. Avoid the starter
grip springing back against the engine. Feed it back
slowly by hand to ensure that the cover is not dam-
aged.
Shut the engine off
1 Switch the generator off
2 Set the engine switch to off
3 Turn the fuel valve to off
In an emergency, set the engine switch to off
WARNING
Electrical devices that can be connected
This power unit can power light bulbs, heaters, drills,
water pumps, etc. Do not exceed the load limit specied
for the power unit.
The power unit may not be used to power devices
that have a high power requirement.
The power unit cannot be used for precision devices
such as computers. These precision devices may be
damaged by distortions caused by the broad wave when
the power unit‘s power is output.
Do not connect the power unit to the electrical installa-
tion of a building.
WARNING: Connection to the electrical installation
of a building may result in the electric current being
returned to the mains supply wires.
This return causes a risk of a fatal electric shock
for employees of the electricity supplier or other
persons who touch the wires during a power failure.
Connection to the electrical installation of a building
can also cause the electric current of the electricity
supplier to return to the power unit. When the mains
supply is restored, the power unit may explode, burn
or cause a re to break out in the electrical installa-
tion of the building.
AVVISO: non utilizzare come messa a terra condotte
in cui passano sostanze inammabili.
Avviare il motore (Fig. 5)
AVVERTENZA: non collegare l‘apparecchio elettrico
prima di avviare il motore.
1 Ruotare il rubinetto del carburante (B) su ON.
In stato freddo:
Portare la leva dello starter (C) in posizione CLOSED.
In stato caldo:
Portare la leva di comando dello starter su OPEN
2. Portare l’interruttore del motore su ON.
3. Tirare lentamente lo starter d‘inversione no a
quando si avverte una resistenza. Quindi tirare
con forza.
4. Riportare la leva dello starter in posizione OPEN
mentre il motore si scalda.
AVVISO: fare attenzione a non ferirsi le dita. Se il
motore non si avvia ed un pistone non è stato solle-
vato completamente, la maniglia di avviamento può
colpire improvvisamente il motore. Evitare che la
maniglia di avviamento colpisca il motore. Accom-
pagnarla indietro lentamente con la mano in modo
che la copertura non venga danneggiata.
Spegnere il motore
1 Spegnere il gruppo elettrogeno.
2 Portare l‘interruttore del motore su off.
3 Portare il rubinetto del carburante su off.
In caso di emergenza, portare l‘interruttore del mo-
tore su off.
AVVISO
Dispositivi elettrici collegabili
Questo gruppo elettrogeno può alimentare lampadine ad
incandescenza, dispositivi di riscaldamento, macchine
foratrici, pompe dell‘acqua ecc. Non superare il limite di
carico indicato per il gruppo elettrogeno.
Il gruppo elettrogeno non può essere utilizzato per
alimentare apparecchi che presentano un elevato
assorbimento di corrente.
Il gruppo elettrogeno non può essere utilizzato per ap-
parecchiature di precisione, come ad esempio compu-
ter. Tali apparecchi di precisione, in alcune circostanze,
possono essere danneggiati dalla distorsione dovuta
all‘onda larga durante l‘erogazione di potenza del grup-
po elettrogeno.
Non collegare il gruppo elettrogeno all‘impianto elettrico
di un edicio.
AVVISO: il collegamento all‘impianto elettrico di un
edicio può avere come conseguenza il feedback
della corrente elettrica nelle linee di alimentazione
di rete.
Tale feedback implica il rischio di scossa elettrica
mortale per gli addetti ai lavori dell‘azienda di forni-
tura di corrente o per altre persone che entrano in
contatto con le linee durante un blackout.
… 51 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach SG2600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach SG2600 in the language / languages: English, German, Dutch, French, Italian, Polish, Swedish, Norwegian as an attachment in your email.

The manual is 9.18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info