781484
30
Zoom out
Zoom in
Previous page
1/148
Next page
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
30 |
17. Trouble shooting
Problem Possible Cause Remedy
Machine cannot be
switched on.




Machine does not work

Power cut.
Motor or switch defective.
Power cut.
Motor or switch defective.
Machine stops during
planing.
Planing blade blunt/worn.
Overload switch has tripped.
Too much chip removal.

Switch on the motor again once it has cooled.


thicknessing.
 -
piece in several passes.
Speed decreases when
planing.
Too much chip removal





Planing blade blunt/worn.

Uneven feed.



at reduced speed.
Machined surface too
rough.

moisture.

Machined surface
cracked.

against the grain.
Too much material planed at
one pass.
Machine the workpiece from the opposite direc-
tion.
Machine the workpiece in several passes.

low during thicknessing.
Thicknesser table resinous




chip ejection obstructed

Too much chip removal.






and thicknessing, chip
ejection obstructed (with

Suction performance too weak. 
the suction connection of at least 20 m/s.
Regular servicing period Before
any
start-up
If
neces-
sary
Once a
week
After 6
months

condition
 X
 X X
  X
 X
󰀨  X

and is in good condition or not worn
 X

Oil or grease all moving connecting parts X X
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach PLM1800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach PLM1800 in the language / languages: English, German, French, Italian, Polish as an attachment in your email.

The manual is 6.63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info