781917
33
Zoom out
Zoom in
Previous page
1/188
Next page
33
Trouble shooting
Problem Cause Remedy
Enginge fails to start
1. Spark plug wire disconnected 1. Attach spark plug wire securely to
spark plug
2. Out of fuel or stale fuel 2. Fill with clean fresh gasoline
3. Throttle control lever not in correct
starting position
3. Move throttle control lever to starting
position
4. Choke not in ON position 4. Throttle must be positioned at choke
for a cold start
5. Blocked fuel line 5. Clean the fuel line
6. Fouled spark plug 6. Clean, adjust gap or replace
7. Engine ooding 7. Wait a few minutes to restart, but do
not prime
8. Engine oil level low (Oil monitor inter-
rupts the ignition circuit) 8. Fill crank case with proper oil
Engine runs erratically
1. Spark plug wire loose 1. Connect and tighten spark plug wire
2. Unit running on CHOKE 2. Move choke lever to OFF
3. Blocked fuel line or stale fuel 3. Clean fuel line. Fill tank wirth clean,
fresh gasoline
4. Vent plugged 4. Clear vent
5. Water or dirt in fuel system 5. Drain fuel tank. Rell with fresh fuel
6. Dirty air cleaner 6. Clean or replace air cleaner
Engine overheats 1. Dirty air cleaner 1. Clean or replace air cleaner
2. Air ow restricted 2. Remove blower housing and clean
Engine will not stop when throttle control
is positioned at STOP, or engine speed
does not increase when throttle control is
adjusted
Debris interfering with throttle linkage Clean dirt and debris
Compactor is dicult to control when
pounding (machine jumps or lurches
forward)
Too high engine speed on hard ground Set the throttle lever at lower speed
Tabela Usterek i Problemów
Problem Przyczyna Sposób rozwiązania
Nie można uruchomić silnika
1. Odłączony przewód świecy zapłonowej 1. Podłączyć przewód do świecy zapłonowej
2. Brak paliwa lub paliwo nieświeże 2. Napełnić czystym świeżym paliwem
3. Dźwignia dławika (ssania) ustawiona w
niewłaściwej pozycji startowej
3. Przesunąć dźwignię dławika (ssania) do
pozycji startowej
4. Nie włączony dławik (ssanie) 4. Dławik musi być ustawiony na ssanie przy
rozruchu zimnego silnika
5. Zatkane przewody paliwowe 5. przeczyścić przewody paliwowe
6. Zanieczyszczona świeca zapłonowa spark
plug 6. Oczyścić lub wymienić
7. Zalany silnik 7. Odczekać kilka minut przed ponownym
startem
8. Niski poziom oleju silnikowego (czujnik
oleju przerywa zapłon) 8. Napełnić zbiornik - wyrównać poziom oleju
Silnik pracuje szarpiąco
1. Odłączony przewód świecy zapłonowej 1. Podłączyć przewód do świecy zapłonowej
2. Zespół pracuje na ssaniu 2. Przełączyć ssanie OFF - wyłączone
3. Przedowy paliwowa zatkane lub nieświeże
paliwo
3. Oczyścić przewody paliwowe.Napełnić
zbbiornik czystym, świeżym paliwem.
4. Zatkany wentyl 4. Oczyścić wentyl
5. Woda lub zanieczyszenia w przewodzie
paliwowym
5. Opróżnić zbiornik. Napełnić nowym, świe-
żym paliwem
6. Zanieczyszczony ltr powietrza 6. oczyścić lub wymienić ltr powietrza
Przegrzany silnik
1. Zanieczyszczony ltr powietrza 1. oczyścić lub wymienić ltr powietrza
2. Ograniczony przepływ powietrza 2. Zdjąć obudowę nawiewu i wyczyścić
nawiew
Silnik nie zatrzymuje się gdy kontrolka prze-
pustnicy ustawiona jest na STOP lub silnik nie
zwiększa obrotów po wprowadzeniu korekcji.
Zanieczyszczenai w przewodach przepustnicy Usunąć zanieczyszczenia
Kompresor wymyka się spod kontroli podczas
uderzeń maszyny (maszyna skacze do tyłu lub
do przodu)
Zbyt wysokie obroty silnika na twardym gruncie Ustawić niższe obroty
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach PC 1300 Kity at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach PC 1300 Kity in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 10.47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info