Manual Scheppach HRS600 (page 21 of 108) (English, German, French, Italian)

781641

Zoom out

Zoom in

1/108

21GB

m Dangers for children and persons with reduced

physical, sensory or mental abilities (e.g. partially

disabled, elderly persons with limitation of their phys-

ical and mental abilities) or lack of experience and

knowledge (e.g. older children).

• Keep children and persons with reduced physical,

sensory or mental abilities away from the cable

hoist and the connecting cable.

• Make sure that children are not playing with or near

the hoist while the hoist is in use.

• Do not leave the cable hoist unattended during

operation.

• Do not let children play with the packaging material.

They can get caught in it and suffocate while playing.

NOTE! Risk of damage! Improper handling of the ca-

ble hoist can lead to damage to the cable hoist.

• Never expose the cable hoist to high temperatures

or weathering (radiant heaters, rain, etc.). Never ll

liquid into the cable hoist.

• Do not use the cable hoist if the plastic or metal

components of the cable hoist have ssures or

cracks, or are deformed.

Safe work

Lifting and lowering loads with the cable hoist

m WARNING!

Risk of injury!

A damaged or incorrectly wound steel cable can

break, cause the load to fall and cause serious injury.

• Always check the entire length of the steel cable

for damage before using the cable hoist.

• If the steel cable is damaged, e.g. bent, cracked or

broken, have it replaced by a specialist.

• Before each use of the cable hoist, check that the

steel cable is correctly wound onto the cable drum

(see Fig.10).

WARNING!

Risk of injury!

• Improper handling of the cable hoist can cause

the load to fall and cause serious injury or death.

• Stay away from the load and the steel cable during

the lifting or lowering process.

• Do not use the cable hoist if persons or animals

are in the immediate vicinity of the cable hoist.

• Do not use the cable hoist if it is visibly damaged.

• Make sure the hook is correctly attached to the load.

• Do not switch directly from forward to reverse, but

halt the cable hoist briey and then switch in the

desired running direction. Otherwise the steel ca-

ble may break and cause the load to fall.

• Make sure that the steel cable does not swing out

more than 15°.

• Stop the load in time when lowering, as the ca-

ble hoist can still run on a few centimetres after

stopping.

• Do not routinely use the emergency stop switch to

stop the cable hoist.

NOTE!

• Risk of damage!

• If the load to be lifted is too heavy, the motor

may overheat and be damaged. The motor has a

thermal circuit breaker, but this does not protect

against overload.

• Do not overload the motor of the cable hoist with

too heavy a load.

• Allow the motor to cool down regularly after longer

periods of work and reduce the weight of the load.

6. Remaining hazards

The machine has been built using modern technol-

ogy and in accordance with recognized safety rules.

Some hazards, however, may still remain.

• The use of incorrect or damaged mains cables can

lead to electrical injuries.

• Although having regarded all considerable rules

there may still remain not obvious remaining haz-

rds.

• Minimize remaining hazards by following the in-

structions in ”Safety Rules”, ”Use only as author-

ized” and in the entire operating manual.

• Danger due to backlash of the load.

• Danger due to touching the steel cable during op-

eration.

• Danger of the steel cable tearing during operation.

7. Technical data

Dimensions LxBxH mm 392/146/174

Single / Double(1)

Rated load 300 kg / 600 kg

Max. hoisting elevation 12 m / 6 m

Hoisting speed 8 m/min / 4m/min

Diameter of the steel wire

rope 4,5 mm

Tensile strength of the steel

wire rope 1770 N/mm2

Weight 17 kg

Rated voltage 230 V~ / 50 Hz

Max. power 1050W

Operating mode S3 20%

Insulation class B

Protection type IP54

Drive unit class M1

Subject to technical changes!

Operating mode S3 – 20% - 10 minutes: S3 = Inter-

mittent mode without in uencing the starting pro-

cess. This means that the maximum operating period

over a time of 10 minutes is 20% (2 minutes).

(1) See chapter 9.3 Increasing the payload

The value of the A-rated noise emissions at the op-

erator’s position is less than 85 dB (sound pressure

level LpA). Sound and vibration values were meas-

ured in accordance with EN 14492-2:2006+A1

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach HRS600 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 2.75 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Scheppach HRS600 Manual

Product: