782133
17
Zoom out
Zoom in
Previous page
1/112
Next page
17
Assembly
For packaging reasons your machine is delivered in semi-
assembled state.
• Attachtheundercarriageandthebaseplatewithphil-
lips head screws M5 x 6 mm.
• Attachthesidecoveringlooselytothebaseframeusing
flat-head screws M8 x 40 mm and screw nuts. Do not
tighten completely.
• Attachthecrossmembertothesidecoveringleftand
right with flat-head screws M 8 x 12 and screw nuts.
• Attachthehousingtothesidecoveringsusingathead
screws M8 x 40 and screw nuts. Securely tighten all
nuts
• Slideinthelterbagoverthecaseandattachitwitha
clamp Position the support bar into the housing and
hang the filter bag from it.
• Attachtheshavingsbagtothelowerairventilatorusing
the clamp.
• Attachtheexhausthosetothenozzleonthehousing
and affix it with a hose clamp.
• Attachthehosecouplingtotheotherendofthehose
using a hose clamp.
The exhaust system should be cleaned every time the
shavings bag is changed.
Damaged filters and bags must be immediately changed
in order to keep the amount of dust that escapes into the
work environment as low as possible.
Initial operation
Notesafetyinstructionsbeforeoperation.Thedataonthe
motor type plate (voltage and frequency) must conform
to the mains supply voltage and frequency. After connec-
tion to the mains, the Dust Extractor ha 1600 is ready for
operation.
m Electrical connection
Connection and repair work on the electrical equipment
must be carried out by a qualified technician only.
The installed electric motor is factory connected ready for
operation.
The connection made by the customer as well as any ex-
tension cables used must comply with all relevant regula-
tions.
Importand note
Defective electrical connection cables
Electrical connection cables often suffer isolation dam-
age.
Possible causes are:
• Pinchpointswhenconnectioncablesarerunthrought
window or door gabs.
• Kinksresultingfromincorrectattachmentoflayingof
Montage
Pour des raisons techniques d’emballage, votre machine
n’estpascomplètementassemblée.
• Raccordezlechâssisetlasemelleàl’aidedesviscru-
ciformes M5 x 6 mm.
• Fixezleshabillageslatérauxsurlastructuredebaseà
l’aide des vis à tête plate M8 x 40 mm et des écrous
papillons.Neserrezpasàfond.
• Fixezla traverseintermédiaire auxhabillages latéraux
gauche et droit à l’aide des vis à tête plate M 8 x 12 et
des écrous papillons.
• Fixez fermement le carter sur les habillages latéraux
à l’aide des vis à têtes plates M8 x 40 et des écrous
papillons.
• Glissez le sac ltre sur le support et xezle à l’aide
d’une bande de fixation, insérez la poignée dans le lo-
gement et accrochez le sac à filtre.
• Fixezlesacàrésidusauniveaudelasortied’airàl’aide
d’une bande de fixation.
• Insérezletuyaud’aspirationsurlasortieauniveaudu
carter et fixez-le l’aide d’un collier.
• Fixezleraccorddetuyauàl’autreextrémitédutuyauà
l’aide d’un collier.
L’aspirateur doit être nettoyé à chaque changement du
sac à résidus.
Il est impératif de remplacer tout filtre ou sac abîmé afin
delimiteraumieuxlesémanationsdepoussièresdansla
zone d’intervention.
Mise en route
Observer les consignes de sécurité avant la mise en route.
Les données indiquées sur la plaque signalétique du mo-
teur (volts et hertz) doivent concorder avec la tension et la
fréquence du secteur.
L’installation d’aspiration ha 1600 est prête au fonction-
nementaprèsl’avoirraccordéeauréseau.
m Branchement Électrique
Seul un électricien spécialisé a le droit de brancher et de
réparer l’équipement électrique.
Le moteur électrique installé est raccordé de façon à être
prêt au fonctionnement. Le branchement correspond aux
prescriptionscorrespondantesVDEetDIN.
Le branchement au secteur effectué par le client ainsi
que la rallonge utilisée doivent correspondre à ces pres-
criptions.
Importantes consignes
Lignes de branchement électrique défectueuses
L’isolement des lignes de branchement électrique est sou-
vent endommagé.
Des causes possibles sont :
• Empreintes lorsque les lignes de branchement sont
conduites à travers des fentes de fenêtre ou de porte.
• Plissuiteàunexationouuneconduiteinadéquatede
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach HA1600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach HA1600 in the language / languages: All languages as an attachment in your email.

The manual is 2.14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info