Manual Scheppach FORSA 4.1 (page 32 of 44) (English, German)

781492

Zoom out

Zoom in

1/44

32 english

Pre-cutter, Fig. V

IMPORTANT: Only insert sharpened, ﬂawless, not deformed

original Scheppach saw blades.

Replace the table insert when a sawing gap is made.

BE CAREFUL! Disconnect power plug when changing blades

1 Retain arbour

2 Flat headed screw M8

• Slide format sliding table forwards, open the protection

cover with both hands.

• Insert the retain arbour (1) through the borehole of the right

table half into the saw axle. Block the saw axle with the

retain arbour to loosen or tighten the ﬂat headed screw (2).

• Pay attention to the saw blade direction.

Fig. W, Y

• The overhang of the pre-cutter saw blades on the table

surface is, depending on the cutting width of the machine’s

saw blades 1.0 – 2 mm.

• The height adjustment is carried out by means of the screw

(2) Fig. V.

• 1 turning is 1.5 mm (picture Y)

• The width of the pre-cutter saw blades is adjusted with the

spacer (A) (1 x 0.1 mm, 2 x 0.2 mm, 1 x 0.3 mm) see Fig.

• The pre-cutter should be as wide as the machine’s saw

blades.

2,8 mm – 3,6 mm are possible

• The ﬂight of the pre-cutter saw blades to the machine’s saw

blades are adjusted by screw (3) picture V

• 1 turning is 0.1 mm (picture Y)

Carry out trial cut.

Lower the pre-cutter with the screw (2) under the table level

when not in use.

Attention! Close protective cover again.

Abb. V

Abb. W

Abb. Y

4SW 5

0,1 mm/

1,5 mm/

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach FORSA 4.1 in the language / languages: English, German as an attachment in your email.

The manual is 6.09 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Scheppach FORSA 4.1 Manual

Product: