781637
17
Zoom out
Zoom in
Previous page
1/44
Next page
Maintenance
Replacing the grinding disc (Fig. 8.1, 8.2)
Remove the sand paper (1).
Insert the Allen key (3) into the hexagonal hole in the centre of the
grinding disc (2) and turn it clockwise to remove the damaged grin-
ding disc (2).
Insert the new grinding disc (2) and tighten it again.
Replacing the carbon brushes
The carbon brushes are wear parts that wear out during use. The car-
bon brushes should therefore be checked regularly. To prevent damage
to the circuit, the two carbon brushes must be replaced at the same
time.
ATTENTION!
The carbon brushes may only be replaced by authorised service perso-
nnel. The device must only be used with both brushes.
Cleaning
Clean the device after each grinding process
Regularly cleaning the device can extend its service life and reduce
the amount of repair work required.
We recommend cleaning the connection pieces and components of
the electrical motor without water.
The parts should be cleaned immediately after use.
Clean the parts with a hairbrush and a dry cloth.
Service
Only have your electrical device cleaned by qualied specialised perso-
nnel and only use spare parts with identical designs. This ensures the
technical safety during use.
Storage
The device, the operating manual as well as accessories, if applicable,
must be stored in the original packaging. In this way, you will always
have all information and parts at your disposal when required. Pack the
device carefully or use the original packaging in order to prevent dama-
ge during transport. Always store the device in a dry location.
GB
17
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach DS200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach DS200 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3.36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info