12 english
Possible causes are:
window or door gaps.
the connection cable.
of the wall socket.
Such defective electrical connection cables must not be
used as the insulation damage makes them extremely haz-
ardous.
Check electrical connection cables regularly for damage.
Make sure the cable is disconnected from the mains when
checking.
Electrical connection cables must comply with the regula-
tions applicable in your country.
Single-phase motor
-
fied on the motor’s rating plate.
cross-section of 1.5 mm2, and beyond 25 m at least 2.5
mm2.
16 A slow-acting fuse.
Only a qualified electrician is permitted to connect the ma-
chine and complete repairs on its electrical equipment.
In the event of enquiries please specify the following da-
ta:
If a motor has to be returned, it must always be dispatched
with the complete driving unit and switch.
Maintenance
elimination of any malfunctions must only be undertak-
en after turning off the motor.
immediately upon completion of any repair or mainte-
nance work.
when changing tools.
by unscrewing it, cleaned and then sprayed with a dry
lubricant. Grease the threaded spindle.
tool holder and adjust if necessary. In addition, tighten
the hex nut under the bracket.
Accessories
Article Art. No.
Trouble shooting
Problem Possible Cause Help
Motor doesn’t start b) Defective switch, condenser
c) Defective extension cord
a) Check fuse
b) Have an electrician inspect unit
necessary
Drilled holes become
larger than the drill bit
Headstock and tailstock are not parallel. Set up headstock according to the tailstock
tip. Insert carrier into the drilling spindle for
this and position the tailstock with tip up to a
Work piece flatters
while working
a) Working piece becomes loose
while working
b) Work piece is not properly centered
a) Follow the instructions in the operating
manual
b) Follow the instructions in the operating
manual
c) Select a lower rotational speed
Tool rest or tailstock
cannot be clamped
Setting the eccentric clamping
