782179
20
Zoom out
Zoom in
Previous page
1/28
Next page
14
english
Fault Possible cause Remedy
1. Braking action in brake motor
defective
a) Fine-wire fuse on printed circuit in
switch defective
b) Printed circuit in switch defective
a) Open switch and replace  ne-wire
fuse on wafer
b) Open switch, replace wafer. Adjust
brake current. See extra sheet
printed circuit. Electrical work
should only be carried out by an
electrician
2. Saw blade works loose after the
motor switches off
a) Fastening nuts not tight enough
b) Braking action too heavy
a) Tighten nuts M 20 left-hand thread
b) Correct brake current adjustment
Remove small stopper on switch
housing
Correct brake current sensitively
at potentiometer with small
screw-screwdriver
The saw blade must be stationary
8 - 10 sec. after switching off
motor
Reinsert stopper in switch
housing
3. Motor does not start
a) Main fuse defective
b) Extension cable defective
c) Terminals on motor or switch
defective
d) Motor or switch defective
a) Check mains fuse
b) See operating instructions Electrical
connection
c) Have checked by electrician
d) See operating instructions Electrical
connection
4. Motor runs forward or backwards
Capacitor defective
Have replaced by electrician
5. Motor without power, switches off
automatically
Overloaded through
a) blunt saw blade
b) 2-phase operation - motor overheats
a) Fit sharpened saw blade
b) Have extension cable and terminals
checked by electrician
6. Burnt spots on cutting face,
longitudinal cut
cross cut
a) Blunt saw blade
b) Wrong blade
c) Longitudinal feed stop not parallel
to saw blade
d) Slide not parallel to saw blade
a) Fit sharpened blade
b) Fit saw blade for longitudinal
cutting
c) Readjust motor to crossarm or
replace longitudinal feed stop
d) Align slide to saw blade
7. Wrong direction of rotation if three-
phase motor
Socket not correctly connected
Switch polarity at socket
Trouble-shooting plan
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scheppach BSH500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach BSH500 in the language / languages: English, German, Italian as an attachment in your email.

The manual is 1.49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info