Manual Scheppach BCH3200PB4 (page 27 of 68) (English, German, Dutch, French, Italian)

672457

Zoom out

Zoom in

1/68

27GB

• Unclip the air lter cover and remove the sponge lter

element.

• To avoid objects falling into the air tank, replace the air

lter cover.

• Wash the lter element in warm soap water, rinse and

allow drying naturally.

Important: Never clean the air lter with petrol or

inammable solvents.

m Warning!

Never run the engine without the air lter element

installed.

Checking the oil level

m CAUTION! Never run the engine with no or too little

oil. This could cause severe damage to the engine. Use

only SAE30 / 10W30 engine oil.

Checking the oil level (Fig. 45):

• Laying unit on a at surface.

• Unscrew the oil dip stick by turning anticlockwise, pull

out and wipe. Insert the dip stick back in the lling

mount as far as the stop.

• Pull out the dip stick again and read off the oil level

while holding horizontally. The oil level must be bet-

ween the maximum and the minimum

Changing the oil (Fig. 44-45)

• Change the engine oil every year before the start of

the season when the engine is warm.

• Use only engine oil (SAE30 / 10W30).

• Open the oil ller screw ( 23).

• Drain the warm engine oil into a drip tray.

• Fill up with engine oil as far as the top mark on the

dipstick (approx. 0.315 l).

Dispose of the used oil in accordance with appli-

cable regulations.

Lubricate angle transmission

Lubricate with lithium-based grease. Remove the screw

and put in the grease, turning the shaft manually until

grease emerges, then replace the screw.

Storing the unit

After cutting, clean the unit thoroughly. Store the unit in a

dry room allow the motor to cool down beforehand.

Important hint in case of sending the equipment to a

service station:

Due to security reasons please see to it that the

equipment is sent back free of oil and gas!

11. Storage

Cleaning

• Keep handles free of oil, so you always have a secure

hold.

• Clean the equipment as required with a damp cloth

and, if necessary, mild washing up liquid.

m Important!

• Always pull out the spark boot plug each time before

carrying out any cleaning.

• Never immerse the equipment in water or other liquids

in order to clean it.

• Store the chainsaw in a safe and dry place out of the

reach of children.

Storage

Important: Never put the equipment into storage for

longer than 30 days without carrying out the following

steps.

Storing the equipment

If you intend to store the equipment for longer than 30

days, the equipment must be prepared accordingly.

Otherwise the fuel still remaining in the carburetor will

evaporate and leave a rubbery sediment. This can cau-

se problems when starting up the equipment and may

require expensive repairs.

1 Slowly remove the fuel tank cap to release any pres-

sure that may have formed in the tank. Carefully empty

the tank.

2 To remove the fuel from the carburetor, start the engine

and let it run until the equipment stops.

3 Leave the engine to cool (approx. 5 minutes).

4 Remove the spark plug (see section 10 Change and

clean the spark plug).

5 Add one teaspoon of 4-stroke engine oil into the com-

bustion chamber. Slowly pull the starter cord several

times to apply a layer of oil to all internal components.

Fit the spark plug again.

Note: Store the equipment in a dry place and far away

from possible ignition sources such as an oven, a gas-

red hot water boiler, a gas- red dryer, etc.

Putting the equipment back into operation

1 Remove the spark plug (see section 10 Change and

clean the spark plug).

2 Quickly tug on the starter cord to remove excess oil

from the combustion chamber.

3 Clean the spark plug and check that the electrode gap

is correct, or insert a new spark plug with the correct

electrode gap.

4 Prepare the equipment for operation.

5 Fill the tank with proper fuel locations.

6 Check it the oil level.

Transport

To transport the machine, empty the petrol tank as

described in section 8 draining fuel. Clean coarse dirt off

the equipment with a brush or hand brush.

12. Disposal and recycling

The equipment is supplied in packaging to prevent it

from being damaged in transit. The raw materials in

this packaging can be reused or recycled. The equip-

ment and its accessories are made of various types of

material, such as metal and plastic. Defective compo-

nents must be disposed of as special waste. Ask your

dealer or your local council.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Scheppach BCH3200PB4 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 7 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Scheppach BCH3200PB4 Manual

Product: