Learning Function
The learning function is used to extend the pre-programmed codes. The
standard code list already provides you with the most important functions, but
it is possible to add a few additional functions. A fully functional original
remote control is required for learning programming.
Please use fresh batteries for both the Learning Remote Control and the
Original Remote Control.
1. Press down and hold the device button which you wanted
to learn (e.g. BD player), and press find button at the
same time, when LED turns on then release the both
pressed keys, now remote control is in learning mode for
BD codes.
2. Point the IR transmitter of the original remote control
remotes face to the IR receiver of your RCU660 remote by
approximately 30 mm apart. Keep two remotes at the
same straight line to make the learning process more
accurate.
3. Press and release the target button on your RCU660
remote control which you want to learn (e.g. info), the
LED starts to flash.
4. Press the one button (For example, info button) from
your original remote control, when you see LED on new
universal remote control flashes three times and stop, it
means RCU660 has accepted new code and now you can start to learn
another new code from original remote.
5. Repeat step 3 to 4 to learn another code from original remote control.
6. When you finish learning all buttons you want to have, press find button to
store all commands you have learnt from original remote and exit from
Learning remote.
11
