633311
21
Zoom out
Zoom in
Previous page
1/24
Next page
SCHAERER OPAL User instruction
BAOP - 02 - V04 Page 69
6. When the cleaning indicator (2a) and
themonitor lamp both begin to blink
simultaneously, rinse out the water
tank thoroughly, fill it with fresh water
and put it back in position Fill the water
tank with cold water, taking care not
to fill it above 1-2 cm below the rim.
7. Now press the cleaning button (2)
again, and the entire system will be
flushed with fresh water. (If the red con-
trol lamp (2a) is still illuminated but the
water tank is already empty, fill ap-
proximately 1 litre of water into the wa-
ter tank and replace it.). Once the signal
lamp (2a) and descaling icon (16) are
no longer lit up, turn the hot water /
steam dial to centre position and re-
place the grounds container. The appli-
ance is now free of limescale and ready
to dispense coffee.
Iportant: Regular descaling will protect your
coffee maker from expensive repairs. Any
damage to the appliance resulting from
omission of this treatment, failure to follow
the correct procedure or from non-
compliance with these instructions is ex-
cluded from warranty cover. The use of
vinegar for descaling purposes is expressly
prohibited as this would damage the coffee
maker
14.0 Possible malfunctions, their causes
and remedies
Please read the following information carefully before you send your coffee
maker back for repair. This will often solve the problem and save you a lot of
time and trouble.
1. Appliance does not respond when the switch is pressed
- The 0-1 mains power switch is not switched on.
- The power cable is not properly connected or you have a defective
fuse.
2. The indicator flashes
- The brewing unit is not correctly inserted or the service access hatch
is not properly closed - check these.
The indicator and a number light up on the programming dis-
play.
- A malfunction has occurred which must be repaired by an authorised
specialist.
3. Flashing or permanently lit signal lamps or icons
- Please refer to the section explaining the meaning of these mes-
sages.
4. The pump emits a loud noise and / or the indicator lights up
- The water tank is incorrectly positioned and there is air in the system.
Reposition the water tank correctly and purge the system of air by
turning the hot water / steam dial to the hot water position until water
flows out steadily. Then return the dial to centre position and the icon
will go out when you press a coffee selection button.
Note: It is normal for the water pump to start up occasionally when the
appliance is operating. It constantly refills the system automatically.
5. The coffee obtained has no froth
- You are using an unsuitable coffee blend or the coffee is stale.
- The quantity of coffee you have set to be ground is too small.
- The cups are too cold, use the preheating function.
- You did not wait for the appliance to reach its correct operating tem-
perature.
900'017.002 900'066.001 900'067.001
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Schaerer Opal at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Schaerer Opal in the language / languages: English as an attachment in your email.

The manual is 2,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info