745578
23
Zoom out
Zoom in
Previous page
1/32
Next page
23
VERTICAL LIGHTING
A vertical lighting also ensures an environmentally friendly lighting and helps to keep the glass optimally clean.
For a vertical lighting, you need the following:
¬ 4 pieces of wood approx. 19-25 cm with a weight of approx. 0.4-0.5 kg per piece
¬ 8-10 thin pieces of firewood with a total weight of approx. 300-400 g
¬ 3-4 fire lighters
1
Place the pieces of wood, firewood and fire lighters in the combustion chamber as shown below
2
Set the primary and secondary air controls to maximum in the lighting phase. If the fire is too strong, you may
throttle down the primary air damper (at the left)
CONTINUOUS OPERATION
It is important to obtain as high a temperature as possible in the combustion chamber. This results in best possible use
of the stove and fuel, as well as achieving clean combustion. In this way you will avoid build-up of soot on the combustion
chamber lining and glass pane. During operation, you should not see any smoke; just a movement in the air that indicates
combustion is in progress.
¬ After completing the lighting phase, you should have a good layer of embers in the stove; you can then start operation
of it properly.
¬ Add two pieces of wood at a time: they should be about 0.4 to 0.6 kg in weight and about 20 cm long.
NOTE: The wood must catch fire quickly. This is why we recommend setting the primary air flow fully open.
NOTE: Operating the stove at too low a temperature and with too little primary air can lead to gases igniting, which can
damage the stove.
¬ When adding wood, always open the glass door carefully to prevent smoke escaping.
¬ Never add wood, while the fire is burning nicely.
WARNING ABOUT OVER-FIRING
If the stove is continiously fired with larger amounts of wood than recommended and/or receives too much air, this can
cause a heavy heat development liable to damage both stove and the surrounding walls. We therefore recommend that
you always observe the max. recommended amount of fuel (See under ”Technical Data”).
Fire lighters
Pieces of
firewood
Wood
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Scan 80 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Scan 80 in the language / languages: English as an attachment in your email.

The manual is 4,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Scan 80

Scan 80 User Manual - German - 32 pages

Scan 80 User Manual - Dutch - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info