757568
22
Zoom out
Zoom in
Previous page
1/124
Next page
SDH17-MNW-U_EN - 03/13 - Saunier Duval
- 20 -
MAINTENANCE
EN
9 Troubleshooting
The table below describes a selection of problems with their
possible causes and solutions, see Table 9.1.
If these solutions do not solve the problem contact your usual
installer or call your nearest Saunier Duval ofce.
SYMPTOMS POSSIBLE CAUSES POSSIBLE SOLUTION
The system does not restart immediately
When unit is stopped, it won't restart until 3
minutes have elapsed to protect the system
Wait 3 minutes before starting the unit again
When power is disconnected and reconnected
again, the protection circuit will work for three
minutes to protect the air to air heat pump unit
Wait 3 minutes after inserting the plug and before
starting the unit again
The system does not work at all (the ventilation
does not start)
The power lead is not connected correctly
Connect the power lead correctly
Power supply cut
Reconnect the power supply
The fuse has blown Replace the fuse. Only use the right fuses for
each model. Do not use wire or other material to
replace the fuse. Fires could be caused
Insufcient cooling or heating
Doors and/or windows open
Close the doors and/or windows
Heat source nearby (e.g. lots of people in the
room)
If possible, remove the heat source
The thermostat is set to an excessively high
temperature in cooling mode or excessively low
temperature in heating mode
Set the temperature properly
Obstacle in front of the air inlet or outlet
Remove the obstacle to allow the air to circulate
properly
The ambient temperature has not reached the
designated level
Wait for a few moments
Dirty or blocked air lter Clean the air lter (the air lter should be cleaned
every 15 days)
Is there any direct sunlight through the window
during the cooling operation?
Use a curtain to protect the Air to Air heat pump
unit
Noise is heard During unit operation or when stopping the unit a
gurgling noise may be heard. This noise is more
audible the rst 2-3 minutes of operation
This is normal in an Air to Air heat pump unit. The
noise is caused by the refrigerant owing in the
system).
A cracking noise is heard during operation This is normal in an Air to Air heat pump unit.
The noise is caused by the casing expanding or
shrinking due to the temperature changes
If the noise is loud and comes from the louvers
during the unit operation, the air lters may be
too dirty
Clean the air lters properly
Smells are generated This is because the system circulates smells from
the indoor surrounding (furniture, cigarettes)
This situation does not require any action
Mist or steam come are blown out from the unit
During COOL mode or DRY mode operation, the
indoor unit may blow some mist. This is due to
the sudden cooling of the indoor air.
This situation does not require any action
Table 9.1 Troubleshooting.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Saunier Duval SDH 17 Multi at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Saunier Duval SDH 17 Multi in the language / languages: German, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 3,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info