757569
35
Zoom out
Zoom in
Previous page
1/136
Next page
SDH17-NW-U_EN - 05/14 - Saunier Duval
- 11 -
OPERATING INSTRUCTIONS
EN
7.3 Advice on how to use the remote
controller
Follow the recommendations below as to how to use the remote
controller:
When in use, direct the head of the signal transmitter directly
to the indoor unit receiver.
Keep the distance between the transmitter and the receiver
within 7 m.
Avoid obstacles between the transmitter and the receiver.
If experiencing difculties with the remote control
communicating with the indoor unit, reduce the distance
between the remote controller and the indoor unit.
Do not drop, throw or hit the remote controller.
7.3.1 Remote controller lock
In order to lock the buttons and display of the remote controller
device:
Press and hold the - & + buttons, at the same time for over
two seconds.
The rest of the buttons are deactivated.
The lock status indicator appears.
In order to deactivate the lock:
Press and hold the - & + buttons, at the same time again.
The rest of the buttons are activated.
The lock status indicator disappears.
7.3.2 Light function
Press the LIGHT button for less than 2 seconds to light the
display of the Indoor Unit. To switch the display back off, press
the LIGHT button for less than 2 seconds once again.
7.4 Switching the unit on and off
In order to switch the unit on:
Press the ON button on the remote controller; the unit will
start to operate.
In order to switch the unit off:
Press the OFF button on the remote controller; the unit will
stop.
7.5 Selection of the operation mode
7.5.1 Automatic mode (AUTO)
In automatic mode (AUTO) the Air to Air heat pump unit
automatically selects the cooling (COOL) or heating (HEAT)
mode in accordance with the actual ambient temperature.
In COOL mode the set room temperature is 25º C. Above
this room temperature the unit will operate in COOL mode.
In HEAT mode the set room temperature is 20º C. Below this
room temperature the unit will operate in HEAT mode.
Fig. 7.3 Automatic mode selection.
Legend
1 MODE button
2 - / + button
3 AUTO mode indicator
In order to activate:
With the unit switched on (see section 7.4):
Press the MODE button.
The different operation modes are displayed.
Fig. 7.4 Operation modes.
Select the automatic operation mode (AUTO).
Press the TEMP / TIME buttons to select the temperature
setting.
When pressing the - / + buttons, the temperature conguration
will increase or decrease by 1ºC.
1
2
3
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Saunier Duval SDH 17 Mono at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Saunier Duval SDH 17 Mono in the language / languages: German, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 4,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info