699897
2
Zoom out
Zoom in
Previous page
1/4
Next page
2 MGD-300 SATEL
Electronics board
CR123A lithium battery.
TST pins to enable/disable the test mode. The
test mode is enabled when the jumper is set
as shown in Fig. 2.
tamper contact.
potentiometer for adjustment of detection
sensitivity (Fig. 4).
microphone.
The LED is placed on the other side of the
electronics board.
LED
The LED is working for 20 minutes after battery is
inserted or tamper contact is opened, as well as in
the test mode. The LED indicates:
periodic transmission – short flash
(80 milliseconds),
test mode – short flash every 3 seconds,
alarm – ON for 2 seconds.
Battery status control
When the battery voltage is below 2.6 V,
information about low battery is sent during each
transmission.
3. Selecting a mounting location
The detector is designed for indoor installation.
The preferred location to install the detector is the wall situated opposite to the protected
glass pane.
The distance between the detector and the protected glass pane must not exceed the
detection range.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Satel MGD-300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Satel MGD-300 in the language / languages: English as an attachment in your email.

The manual is 0,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Satel MGD-300

Satel MGD-300 User Manual - German - 4 pages

Satel MGD-300 User Manual - Dutch - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info