699079
93
Zoom out
Zoom in
Previous page
1/114
Next page
SATEL INTEGRA 91
signaling stops after the maximum duration of acoustic signaling elapses, even if the
control output is still active. The optical signaling is active as long as the output is active.
ASP-205 / ASP-215 both outputs control acoustic and optical signaling. Thus two different,
independently triggered ways of signaling can be configured. As a result, the outputs can
separately control the optical and acoustic signaling or trigger other signaling for different
alarms (e.g. burglary and fire). The command to start the signaling is sent to the siren only
during the response time. Therefore, the cut-off time for the control panel outputs which
control the siren must be longer than the response period. It is recommended that cut-off
time correspond to maximum duration of signaling programmed for the siren. The signaling
stops after the maximum duration of signaling elapses, even if the control output is still
active.
The zones to which the wireless siren is assigned are activated if a siren power supply
trouble occurs (select the appropriate reaction type for the zones):
ASP-105first zone: low battery; second zone: 12 V DC power loss.
ASP-205 / ASP-215both zones: low battery.
If the siren tamper is to trigger tamper alarm, program the zone as 2EOL/NC or 2EOL/NO.
The tamper information is sent immediately, while the trouble information during the
response time.
Tamper alarm on opening the tamper switch in the siren:
ASP-105 lasts for the maximum time of acoustic signaling programmed for the siren (sound
type selected during programming and optical signaling),
ASP-205 / ASP-215lasts 3 minutes (sound type 1 and optical signaling).
After starting the SERVICE MODE or TEST MODE and for 40 seconds after power-up, the
signaling in the siren is blocked. It enables installation work to be carried out. Opening
the tamper switch will not trigger loud signaling, but information on tamper will be sent
(when in service mode, the control panel will not signal the tamper alarms). The
command to block/unblock the signaling connected with starting / ending the test
mode or the service mode is sent during the response time.
9.3.3 Wireless expanders of hardwired zones and outputs
The wireless expander of hardwired zones and outputs (ACX-200 / ACX-201 / ACX-210 /
ACX-220) takes up 4 zones and 4 outputs in the system. You can configure the alarm system
zone/output to which expander zone/output is assigned in much the same way as hardwired
zones/outputs. You should remember however that sensitivity of the expander zones may be
different from that programmed in the control panel:
from 20 ms to 140 ms – the same as the value programmed in the control panel,
above 140 ms only some values are available: 400 ms, 500 ms, 700 ms, etc. every
200 ms (the programmed value is rounded up to that supported by the expander).
The EN50131-3 standard requires that zones must react to signals lasting more than
400 ms. Therefore, select 400 ms when programming sensitivity of the alarm zones.
Information on the state of zones and commands to change the state of outputs are sent
immediately. Zone settings are sent during the response time (in one period, data relating to
configuration of one zone are sent to the expander module, i.e. sending the information on
settings of four zones require four response periods).
If communication with the control panel is lost, all previously activated outputs will be
deactivated after 20 response periods.
Additionally, the ACX-201 expander module sends information about:
status of AUX1 and AUX2 power supply outputs information on overload is sent when
the AUX1 or AUX2 output load exceeds 0.5 A.
93


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Satel Integra 24 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Satel Integra 24 in the language / languages: English as an attachment in your email.

The manual is 1,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Satel Integra 24

Satel Integra 24 User Manual - English - 51 pages

Satel Integra 24 Installation Guide - English - 36 pages

Satel Integra 24 Quick start guide - German - 2 pages

Satel Integra 24 User Manual - German - 54 pages

Satel Integra 24 Additional guide - German - 121 pages

Satel Integra 24 Installation Guide - German - 38 pages

Satel Integra 24 Quick start guide - Dutch - 24 pages

Satel Integra 24 User Manual - Dutch - 52 pages

Satel Integra 24 Additional guide - Dutch - 121 pages

Satel Integra 24 Installation Guide - Dutch - 35 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info