699761
7
Zoom out
Zoom in
Previous page
1/12
Next page
SATEL AXD-200 5
Test mode
The test mode makes the detector testing easier, because the LED indicator is enabled. How
to start and end the test mode is described in the ABAX 2 / ABAX controller manual / the
INTEGRA 128-WRL control panel manual.
LED
The LED is flashing rapidly for about 10 seconds after the battery is inserted to indicate that
the process of selecting the detector type can be initiated (see “Selecting detector type”).
The LED also works in the test mode, in which it indicates:
periodical communication – short flash (80 milliseconds),
alarm – ON for 2 seconds.
Battery status control
When the battery voltage is below 2.75 V, information about low battery is sent during each
transmission.
Electronics board
Do not remove the electronics board from the enclosure to
avoid damage to the components on the board.
Fig. 2 shows the detector inside after opening the enclosure.
terminal block:
COM - common ground.
M1 - input supported in the case of the AMD-200, AMD-201,
AMD-202 and AFD-200 detectors. It allows connection of
an NC type detector (AMD-200 / AMD-201 / AMD-202) or
the flood probe (AFD-200).
M2 - input supported in the case of the AMD-202 detector. It
allows connection of the roller shutter detector.
To make the connection, use wires with a cross-section of 0.5-
0.75 mm
2
. If no detector or flood probe is connected to the input,
the terminal must be connected to common ground.
tamper contact.
CR123A lithium battery.
3 Installation
There is a danger of battery explosion when using a different battery than
recommended by the manufacturer, or handling the battery improperly.
Be particularly careful during installation and replacement of the battery. The
manufacturer is not liable for the consequences of incorrect installation of the
battery.
The used batteries must not be discarded, but should be disposed of in
accordance with the existing rules for environment protection.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Satel AXD-200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Satel AXD-200 in the language / languages: English as an attachment in your email.

The manual is 0,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Satel AXD-200

Satel AXD-200 User Manual - German - 13 pages

Satel AXD-200 User Manual - Dutch - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info