699875
7
Zoom out
Zoom in
Previous page
1/10
Next page
SATEL AOD-200 5
2. Install the battery and secure it with the clip you will find in the package.
3. Add the detector to the wireless system (see the ACU-120 / ACU-270 controller manual or
the INTEGRA 128-WRL / VERSA / VERSA Plus / VERSA IP control panel installer
manual). The sticker with 7-digit serial number which shall be entered when registering
the detector in the system can be found on the electronics board.
4. Replace the cover.
5. Fasten the detector temporarily at the place of its future installation.
6. Check the level of signal received from the detector by the ACU-120 / ACU-270 controller
or the INTEGRA 128-WRL control panel. If the signal level is lower than 40%, select
another place for installation. Sometimes, it is sufficient to shift the device ten or twenty
centimeters to obtain a considerable improvement in the signal quality.
7. Remove the front cover (Fig. 4).
8. Remove the electronics module (Fig. 5).
9. If the detector is to be mounted on angle bracket or ball bracket, make a hole in the
enclosure base for the additional tamper switch cables.
10. Mount the enclosure base to the wall, to the angle bracket (see: “Angle bracket
mounting”) or to the ball bracket (see: “Ball bracket mounting”). Use screw anchors
suitable for the mounting surface (concrete wall, drywall, etc.). The screw anchors should
guarantee required mechanical strength. In Figure 6 possible ways of mounting the
detector are shown.
11. Having secured the detector, mount the electronics module and replace the cover.
12. Configure the detector settings:
sensitivity of PIR sensor,
sensitivity of microwave sensor,
sensitivity of dusk sensor (detection threshold).
For description on how to configure the detector, refer to the ACU-120 / ACU-270
controller manual or the INTEGRA / VERSA / VERSA Plus / VERSA IP control panel
programming manual.
If the detector is to be pet immune, for the infrared and microwave sensors do not set
the detection sensitivity higher than default.
13. Start the test mode and check that the motion within the detector area will light up the
LED. Fig. 11 shows:
- the maximum coverage area, - creep zone.
14. End the test mode.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Satel AOD-200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Satel AOD-200 in the language / languages: English as an attachment in your email.

The manual is 0,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Satel AOD-200

Satel AOD-200 User Manual - German - 10 pages

Satel AOD-200 User Manual - Dutch - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info