699762
6
Zoom out
Zoom in
Previous page
1/7
Next page
4 AGD-200 SATEL
with serial number which shall be entered when registering the detector in the system can
be found on the electronics board.
In the INTEGRA / VERSA alarm system, the detector is identified as AGD-100.
Simultaneous operation of the detector by the ABAX 2 and ABAX controller /
INTEGRA 128-WRL alarm control panel is not possible.
3. Close the detector enclosure.
4. Put the detector at the place of its future installation.
5. Check the level of signal received from the detector by the ABAX 2 / ABAX controller or
the INTEGRA 128-WRL control panel. If the signal level is lower than 40%, select another
place for installation. Sometimes, it is sufficient to shift the device ten or twenty
centimeters to obtain a considerable improvement in the signal quality. You can also try to
turn the enclosure to check what effect the change of antenna position will have on the
signal strength.
The ARF-200 tester makes it possible to check the radio signal strength at the place of
future installation without having to put the detector there.
6. Start the test mode (see the ABAX 2 / ABAX controller manual / the INTEGRA 128-WRL
control panel manual).
7. Place the INDIGO TESTER close to the protected glass and use it to generate a glass-
break sound. If the detector LED comes on, continue the installation. Otherwise, change
the detection sensitivity (see the ABAX 2 / ABAX controller manual / the
INTEGRA 128-WRL control panel manual) or select another installation location and
repeat the test (the level of signal received from the detector must be rechecked).
8. End the test mode.
9. Open the detector enclosure (Fig. 4).
10. Use wall plugs (anchors) and screws to secure the enclosure base to the mounting
surface (Fig. 6). The wall plugs delivered with the device are intended for concrete, brick,
etc. For other types of surface (drywall, styrofoam), use the appropriately selected wall
plugs.
11. Close the detector enclosure.
12. Configure the detector settings (see the ABAX 2 / ABAX controller manual / the
INTEGRA 128-WRL control panel manual).
5. Specifications
Operating frequency band................................................................... 868.0 MHz ÷ 868.6 MHz
Radio communication range (in open area)
ABAX 2
ACU-220 ..............................................................................................up to 2000 m
ACU-280 ..............................................................................................up to 1200 m
ABAX..............................................................................................................up to 500 m
Battery.................................................................................................................... CR123A 3 V
Battery life expectancy.......................................................................................... up to 2 years
Temperature measurement range .......................................................................-10°C...+55°C
Temperature measurement accuracy ................................................................................ ±1°C
Standby current consumption .......................................................................................... 90 µA
Maximum current consumption ........................................................................................25 mA
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Satel AGD-200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Satel AGD-200 in the language / languages: English as an attachment in your email.

The manual is 0,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Satel AGD-200

Satel AGD-200 User Manual - German - 7 pages

Satel AGD-200 User Manual - Dutch - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info