699881
2
Zoom out
Zoom in
Previous page
1/4
Next page
2 AGD-100 SATEL
four seconds from receiving the low-frequency sound wave, caused by the impact.
Sensitivity of the high-frequency channel is set by radio.
Electronics board
Figure 1 shows the inside of the detector.
CR123A lithium battery.
tamper contact.
microphone.
The LED is placed on the other side of the electronics board.
Alarms
The detector reports alarm in the following cases:
glass break detection,
opening the tamper contact (tamper alarm).
Operating modes
The detector operating mode is defined remotely.
Active – information about each alarm is sent immediately.
Passive – information about tamper alarm is sent immediately, while
information about glass break detection only during the polling
time. This operating mode prolongs the battery life.
Test mode
f you want to test the detector, you can remotely enter the test mode.
When in the test mode, the detector LED is working.
LED
The LED is working for 2 minutes after battery is inserted, as well as in the test mode. The
LED indicates:
polling – short flash (80 milliseconds),
registering a low-frequency sound – flash (500 milliseconds),
alarm – registering a high-frequency sound or opening the tamper contact – ON for 2
seconds.
Battery status control
When the battery voltage is below 2.75 V, information about low battery is sent during each
transmission.
Note: For additional information about the detector and its configuration please refer to the
manual for ABAX wireless system controller.
4. Installation
The detector is designed for indoor installation, attached directly to the wall. The protected
glass surfaces must remain within the device detection range.
Curtains, drapes, furniture upholstery, acoustic tiles, etc. absorb the sound and
adversely affect the detection range.
Be particularly careful during installation and replacement of the battery. The
manufacturer is not liable for the consequences of incorrect installation of the
battery.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Satel AGD-100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Satel AGD-100 in the language / languages: English as an attachment in your email.

The manual is 0,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Satel AGD-100

Satel AGD-100 User Manual - German - 2 pages

Satel AGD-100 User Manual - Dutch - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info