783746
14
Zoom out
Zoom in
Previous page
1/29
Next page
12
Stand 09/2013 WB / 06/2017 IH / 07/2018 TM
ANSCHLUSS
Schließen Sie das Gerät nur an eine Schutzkontaktsteckdose
mit Erdung und einem 230 Volt Anschluss.
Bevor Sie das Gerät anschließen, vergewissern Sie sich, dass
die Spannung und die Frequenz der Strom-versorgung mit
den Angaben auf dem Typenschild übereinstimmen! Andere
Spannungen können zur Überhitzung des Gerätes führen!
Der Stecker muss geerdet sein. Sollten Sie das Kabel ersetzen
müssen, benutzen Sie unbedingt ein entsprechendes
geerdetes Kabel.
Bitte beachten Sie, dass der Anschluss lediglich durch einen
erfahrenen Elektriker erfolgen darf.
Wenn das Kabel beschädigt ist, sollte es bei entweder dem
Hersteller oder einem Service Vertreter ersetzt werden um
Gefahr zu vermeiden.
The plug must be earthed. If you need to replace the cable, be
sure to use an appropriate grounded cable.
Please note that the connection may only be made by an
experienced electrician.
If the cable is damaged, it should be replaced by either the
manufacturer or a service representative to avoid danger.
CONNECTION
Connect the device only to a grounded safety socket and a
230 volt connection.
Before connecting the device, make sure that the voltage
and frequency of the power supply correspond to the
information on the type plate! Other voltages can lead to
overheating of the device!
Wenn Sie das Gerät angeschlossen haben, warten Sie etwa eine Stunde, damit der Innenraum
ausreichend herunterkühlen kann, bevor Sie diesen mit Ware bestücken.
Wenn Sie das Gerät angeschlossen haben, warten Sie etwa eine Stunde, damit der Innenraum ausreichend
herunterkühlen kann, bevor Sie diesen mit Ware bestücken.
Nach Lieferung bzw. einem Transport des Gerätes, schließen Sie dieses erst an, nachdem das Gerät für
mindestens 24 Stunden still gestanden hat. Dies ist unbedingt notwendig, damit sich das Kühlmittel im
Kompressor sammeln kann.
After delivery or transport of the device, connect it only after the device has been stationary for at least 24
hours. This is absolutely necessary so that the coolant can collect in the compressor.
Nach Stromausfall oder wenn das Gerät vom Stromnetz getrennt wurde, warten Sie mindestens 5 Minu-
ten, bevor Sie das Gerät wieder anschließen und in Betrieb nehmen!
Wird das Gerät erneut gestartet, direkt nachdem es ausgeschaltet wurde, kann es passieren, dass die
Sicherung auslöst und den Stromuss unterbricht. Außerdem kann es passieren, dass der Kompressor
überbelastet und beschädigt wird.
After a power failure or if the device has been disconnected from the power supply, wait at least 5 minu-
tes before reconnecting the device and putting it into operation!
If the unit is restarted immediately after it has been switched o, the fuse may trip and the current ow may
be interrupted. In addition, the compressor may be overloaded and damaged.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Saro TORE GN 700 TN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Saro TORE GN 700 TN in the language / languages: English, German as an attachment in your email.

The manual is 3.93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info