783740
10
Zoom out
Zoom in
Previous page
1/14
Next page
IR 02-2021
10
Nach Lieferung bzw. einem Transport des Gerätes, schließen Sie dieses erst an, nachdem das Gerät für
mindestens 24 Stunden stillgestanden hat. Dies ist unbedingt notwendig, damit sich das Kühlmittel im
Kompressor sammeln kann.
After delivery or transport of the device, connect it only after the device has been stationary for at least 24
hours. This is absolutely necessary so that the coolant can collect in the compressor.
ANSCHLUSS
Schließen Sie das Gerät nur an eine Schutzkontaktsteckdose mit Erdung
und einem 230 Volt Anschluss.
Bevor Sie das Gerät anschließen, vergewissern Sie sich, dass die
Spannung und die Frequenz der Stromversorgung mit den Angaben auf
dem Typenschild übereinstimmen! Andere Spannungen können zur
Überhitzung des Gerätes führen!!!
Wenn Sie das Gerät angeschlossen haben, warten Sie etwa
eine Stunde, damit der Innenraum ausreichend
herunterkühlen kann, bevor Sie diesen mit Ware bestücken.
Nach Stromausfall oder wenn das Gerät vom Stromnetz getrennt
wurde, warten Sie mindestens 5 Minuten, bevor Sie das Gerät wieder
anschließen und in Betrieb nehmen!
Wird das Gerät erneut gestartet, direkt nachdem es ausgeschaltet
wurde, kann es passieren, dass die Sicherung auslöst und den
Stromfluss unterbricht. Außerdem kann es dazu kommen, dass der
Kompressor überbelastet und beschädigt wird.
BETRIEB
Um Energie zu sparen und um zu verhindern, dass kalte Luft entweicht,
halten Sie die Türe immer nur so lange geöffnet, wie es eben notwendig
ist.
Dieses Gerät verfügt über einen Umluftventilator, welcher dafür sorgt,
dass die kalte Luft im Inneren zirkuliert. Die Abstände zwischen den
Einlegeböden und Tür dienen der Luftzirkulation. Achten Sie daher
beim Einräumen Ihrer Waren darauf, dass die Luft frei zirkulieren kann
und keine Waren überstehen oder der Ventilator durch Waren
verdeckt wird. Verteilen Sie die Waren gleichmäßig auf den
Einlegeböden.
CONNECTION
Connect the device only to a grounded safety socket and a 230 volt
connection.
Before connecting the device, make sure that the voltage and
frequency of the power supply correspond to the information on the
type plate! Other voltages can lead to overheating of the device!
If you have connected the device, wait about one hour so that
the interior can cool down sufficiently before loading it with
goods.
After a power failure or if the device has been disconnected
from the power supply, wait at least 5 minutes before
reconnecting the device and putting it into operation!
If the unit is restarted immediately after it has been switched
off, the fuse may trip and the current flow may be interrupted.
In addition, the compressor may be overloaded and damaged.
OPERATION
To save energy and prevent cold air from escaping, only keep the door
open as long as necessary.
This unit has a recirculation fan which ensures that the cold air
circulates inside. The distances between the shelves and the door serve
for air circulation. Therefore, when storing your goods, make sure that
the air can circulate freely and that no goods protrude or the fan is
covered by goods. Distribute the goods homogeneously over the
shelves.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Saro GTK 460 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Saro GTK 460 in the language / languages: English, German as an attachment in your email.

The manual is 1.27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info