783741
6
Zoom out
Zoom in
Previous page
1/16
Next page
IR 02-2022
6
können und deshalb nicht in deren he gelagert werden
dürfen.
Falls eine Aufbewahrung der Verpackung nicht möglich ist, trennen
Sie die verschiedenen Verpackungsmaterialien und liefern Sie diese
bei der nächstgelegenen Sammelstelle zur sachgemäßen Entsorgung
ab.
Stellen Sie das Gerät an einem trockenen und ausreichend belüfteten
Ort auf.
Das Gerät nicht in der Nähe von Wärmequellen, wie Heizung, Herd,
Ofen oder offenem Feuer oder in direkter Sonneneinstrahlung
aufstellen, da dann die gewünschte Kühlleistung nicht mehr
gewährleistet werden kann.
Die Lüftungsschlitze sind immer freizuhalten und dürfen nicht
abgedeckt oder zugestellt werden.
Bevor Sie das Gerät an das Stromnetz anschließen und in Betrieb
nehmen, reinigen Sie das Gerät sorgfältig.
Bohren oder stechen Sie keine Löcher in Innen- oder Außenseite des
Gerätes. Der Kühlkreislauf könnte beschädigt werden.
Aus hygienischen Gründen wird eine gliche Reinigung empfohlen.
Das Gerät ist weder geeignet noch vorgesehen, für die Lagerung von
Medikamenten oder leicht entzündlichen, brennbaren oder
explosiven Stoffen.
SICHERHEITSHINWEISE
Vor der ersten Inbetriebnahme lesen Sie diese Betriebsanleitung
sorgfältig und beachten Sie die darin gegebenen Hinweise.
Falsche Bedienung und unsachgemäße Behandlung können zu
Störungen am Gerät führen und zu Verletzungen des Benutzers.
Beachten Sie die für den Einsatzbereich geltenden
Unfallverhütungsvorschriften und die allgemeinen
Sicherheitsbestimmungen.
Sorgen Sie für einen sicheren Stand auf einem trockenen, dem
Gewicht des Gerätes entsprechend ausreichenden, rutschfesten
Untergrund. Ist der Untergrund nicht stabil genug, kann das Gerät
umkippen und herausfallende Einlegeböden und Produkte können
Verletzungen verursachen.
Sorgen Sie dafür, dass die Lufteinlass- und Abluftöffnungen am
Gerätesockel stets frei von Verunreinigungen sind. Überprüfen Sie
diese regelmäßig und entfernen Sie etwaige Staubablagerungen, mit
Hilfe eines Staubsaugers.
Stellen Sie das Gerät nicht auf eine heiße Oberfläche.
Neigen Sie das Gerät nicht um mehr als 45 Grad.
Bewegen Sie das Gerät nicht während der Benutzung.
Bevor Sie das Gerät bewegen, ziehen Sie den Netzstecker.
Achten Sie darauf, dass das Gerät beim Bewegen nicht kippt. Dies
könnte zu Verletzungen führen.
Steht das Gerät wieder an seinem Platz, warten Sie zwei Stunden,
bevor Sie das Gerät erneut in Betrieb nehmen.
Nach längerem Transport sollte das Gerät erst nach 12 Stunden wieder
in Betrieb genommen werden.
Lassen Sie das Netzkabel nicht über scharfe Kanten hängen und halten
Sie es fern von heißen Gegenständen und offenen Flammen.
Achten Sie darauf, dass ein unbeabsichtigtes Ziehen am Kabel oder
ein Stolpern darüber nicht glich ist.
Beschädigen oder modifizieren Sie das Netzkabel nicht, ziehen
Sie nicht daran, belasten, verbiegen oder quetschen Sie es nicht,
verdrehen Sie es nicht und rollen Sie es nicht auf.
Schützen Sie das Gerät vor Feuchtigkeit.
Reinigen Sie das Gerät nicht mit einem offenen Wasserstrahl.
If it is not possible to store the packaging, separate the
various
packaging materials and deliver them to the nearest
collection point for proper disposal.
Place the unit in a dry and sufficiently ventilated place.
Do not place the unit near heat sources such as heating,
stove, oven, or open fire or in direct sunlight, as the
desired cooling capacity can then no longer be
guaranteed.
The ventilation slots must always be kept clear and must
not be covered or blocked.
Before connecting the device to the power supply and
putting it into operation, clean it carefully.
Do not drill or puncture any holes in the inside or outside
of the unit. The cooling circuit could be damaged.
For hygienic reasons, daily cleaning is recommended.
The device is neither suitable nor intended for the
storage of medicines or highly flammable, flammable or
explosive substances.
SAFETY NOTICES
Before initial operation, read these operating
instructions carefully and observe the information
contained therein.
Incorrect operation and improper handling can lead to
malfunctions of the device and injuries to the user.
Observe the accident prevention regulations applicable
to the area of application and the general safety
regulations.
Ensure that the unit stands securely on a dry, non-slip
surface that matches the weight of the unit. If the surface
is not stable enough, the unit may tip over and cause
injury if shelves and products fall out.
Make sure that the air inlet and exhaust openings on the
unit base are always free of impurities. Check them
regularly and remove any dust deposits with the help of
a vacuum cleaner.
Do not place the unit on a hot surface.
Do not tilt the unit more than 45 degrees.
Do not move the unit during use.
Before moving the unit, unplug the power cord.
Make sure that the unit does not tip over when
moving. This could result in injury.
When the unit is back in place, wait two hours before
putting it back into operation.
After longer transport, the device should only be put
back into operation after 12 hours.
Do not let the power cord hang over sharp edges and
keep it away from hot objects and open flames.
Make sure that it is not possible to pull or trip over the
cable unintentionally.
Do not damage, modify, pull, load, bend, crush, twist,
or unwind the power cord.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Saro EGN 650 TN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Saro EGN 650 TN in the language / languages: English, German as an attachment in your email.

The manual is 1.75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info