104586

Sanyo VPC-SX550EX Manual

26
Zoom out
Zoom in
Previous page
1/52
Next page
PREPARATION OF BATTERIES
Using the Nickel Metal Hydride Batteries
Properly
Periodically clean with a dry cloth the terminals of the nickel metal hydride batteries ((+)
and (–)) and the terminals located in the battery compartment of the digital camera.
Do not touch the battery terminals or the terminals in the battery compartment of the digital
camera with your bare hands. Doing so will allow contaminants from your hands to adhere to
the terminals and oxidize and increase the contact resistance. If the contact resistance
increases, the usable life of the batteries will diminish.
If you repeatedly remove the nickel metal hydride batteries before they run out and recharge
them, or place them into the digital camera before they are fully recharged, then a “memory
effect”* may occur.
Your digital camera is designed to handle the effects from voltage fluctuations caused by the
“memory effect” of nickel metal hydride batteries. Nevertheless, there are times when the
remaining charge indicator may show ( or ) earlier than usual.
If any symptoms such as these occur, first discharge the batteries completely (see page 120)
and then recharge them until they are fully charged again.
* Memory effect
Memory effect is a phenomenon where the battery performance temporarily lowers. In general,
the battery voltage during use drops below its normal voltage until it is fully discharged and
recharged again.
NOTE
New batteries must be recharged before they are first used.
If recharged batteries are stored, they will slowly loose their charge. They must be recharged
before they are used again.
If the batteries are used for the first time or if they have not been used for a long time, they may
not be recharged completely even when the recharge indicator goes off. (The supplied nickel
metal hydride batteries should take approx. 200 minutes to be completely recharged. If the
indicator lamp turns off much earlier than this, the batteries are not fully charged and will soon
run out of power.) The batteries will return to normal after they have been used and recharged
two or three times.
The batteries may have reached the end of their service life if the recharge indicator keeps on
flashing even if the batteries have been inserted correctly, or if they overheat while being
recharged. However, if the same conditions appear with new batteries, or if the recharge
indicator does not go off after approximately 300 minutes, it may indicate a problem of the
battery charger. In such a case, stop using it immediately and take it to the dealer for service.
Two discharged batteries must be recharged at the same time.
During recharging, the battery charger and batteries will be warm. This is normal and does not
indicate a malfunction.
During recharging, the battery charger may create interference with a radio or TV. In such a
case, make sure to plug the battery charger into a power outlet on a circuit different from the
one of the radio or TV.
23 English
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sanyo VPC-SX550EX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sanyo VPC-SX550EX in the language / languages: English as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info