Manual Sanyo SAP-CRV93EH (page 41 of 77) (English)

489455

Zoom out

Zoom in

1/77

.....Applied for only SAP-CRV123 outdoor unit

●

This outdoor DC fan motor contains an internal control PCB. Therefore, it is not possible to measure the coil

resistance, and the following procedure should be used to check the motor.

●

To perform diagnosis, follow the instructions in “Checking the Outdoor Unit” on the previous page and set the

outdoor unit to Test Run mode (compressor ON, outdoor fan motor ON).

Important: (A) Turn OFF the power before connecting or disconnecting the motor connectors.

(B) When performing voltage measurement at the outdoor controller connector for (3) in the table

below, the DC motor will trip and voltage output will stop approximately 10 seconds after

operation is started. For this reason, to measure the voltage again, first turn OFF the outdoor

unit power, then follow the instructions in “Checking the Outdoor Unit” and again set the unit

to Test Run mode.

[Trouble symptom 1] The fan does not stop when the outdoor unit stops.

→

Outdoor unit controller trouble

[Trouble symptom 2] The fan motor does not rotate when the outdoor unit is operating.

(Diagnostic procedure)

* Disconnect the motor connectors and measure the voltage at the DC motor connectors on the outdoor

unit controller (3 locations).

Measurement location Normal value

(1) Vs-Gnd: Between pin 1 and pin 4 DC 230 V or more

(2) Vcc-Gnd: Between pin 5 and pin 4 DC 14 V or more

(3) Vsp-Gnd: Between pin 7 and pin 4 After fluctuating 4 times between DC 1.0 – 4.3 V

(1 sec. ON) and DC 0 V (1 sec. OFF), the DC

motor trips.

(Diagnostic results)

All of the above measured values are normal.

→

Fan motor trouble (Replace the motor.)

Any one of the above measured values is not normal.

→

Outdoor unit controller trouble

(Replace the controller .)

(Reference) DC motor connector pin arrangement

Pin 1: Vs (white)

Pin 2: Not used

Pin 3: Not used

Pin 4: Gnd (black)

Pin 5: Vcc (red)

Pin 6: FG (blue)

Pin 7: Vsp (yellow)

[Trouble symptom 3] Motor rotates for some time (several seconds), but then quickly stops, when the outdoor

unit operates.

(There is trouble in the system that provides feedback of motor rotation speed from the

motor to the outdoor unit controller.)

[Trouble symptom 4] Fan motor rotation speed does not change during outdoor unit operation.

[Trouble symptom 5] Fan motor rotation speed varies excessively during outdoor unit operation.

(Remedy for symptom 3 to 5)

It is not possible to identify whether the trouble is outdoor unit controller trouble or motor trouble.

Therefore, first replace the outdoor unit controller, then (if necessary) replace the DC motor.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Sanyo SAP-CRV93EH in the language / languages: English as an attachment in your email.

The manual is 2,36 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Sanyo SAP-CRV93EH Manual

Product: