45
Appendix
Lamp Replace Counter
Be sure to reset the Lamp Replace Counter after the Lamp assembly is replaced. After the Lamp Replace Counter is reset,
the LAMP REPLACE indicator stops lighting.
NOTE : Do not reset the Lamp Replace Counter before the Projection lamp is replaced.
Turn on the projector and press the MENU button. The main
menu appears. Select the Setting menu with the POINT
UP/DOWN button, and then press the POINT RIGHT button
to enter the sub-menu.
Choose the Lamp counter reset with the POINT UP/DOWN
button, and then press the SELECT button.
1
2
The message “Lamp replace counter reset?” is displayed.
Select "Yes" with the SELECT button, and the other
confirmation display appears. Select "Yes" with the SELECT
button to reset.
The LAMP REPLACE indicator stops lighting after the Lamp
Replace Counter is reset.
3
This projector uses a high-pressure lamp which must be handled carefully and properly. Improper
handling may result in accidents, injury, or create a fire hazard.
● Lamp lifetime may differ from lamp to lamp and according to the environment of use. There is no
guarantee of the same lifetime for each lamp. Some lamps may fail or terminate their lifetime in a
shorter period of time than other similar lamps.
● If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE INDICATOR
lights up, replace the lamp with a new one IMMEDIATELY after the projector has cooled down.
( Follow carefully the instructions in the Lamp Replacement section of this manual. ) Continuous use
of the lamp with the LAMP REPLACE INDICATOR lighted may increase the risk of lamp explosion.
● A Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its
lifetime draws to an end. Risk of explosion may differ according to the environment or conditions in
which the projector and lamp are being used.
IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN.
If a lamp explodes, disconnect the projector’s AC plug from the AC outlet immediately. Contact an
authorized service station for a checkup of the unit and replacement of the lamp. Additionally, check
carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out
from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one
should check the inside of the projector except those who are authorized trained technicians and who are
familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those who
are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken
glass.
LAMP HANDLING PRECAUTIONS
Setting menu
Select "Yes" to reset.
