215459
19
Zoom out
Zoom in
Previous page
1/79
Next page
19
Terminals of Projector
This projector applies various input/output terminals and 4 terminal slots for expansion to tune to diversity
of signals from computers and video equipment. 4-built-in Terminal Slots enable you to arrange desired
combinations of input sources just by changing Terminal Boards. For Terminal Boards, contact sales dealer
where you purchased a projector.
Pull out the terminal by holding handle.
Remove 2 Screws on a terminal.
1
2
Tighten screws to secure the terminal.
Replace the terminal. Insert a new terminal along
Guide to fit Plug into Socket.
3
4
ANALOG
G B R
H/HV
V
DIGITAL (DVI-D)
INPUT 1
R/C JACK
USB
RESET
INPUT 2INPUT 3
INPUT 4
SERIAL PORT IN
SERIAL PORT OUT
L
VIDEO/Y
Pb/Cb
Pr/Cr
S-VIDEO
INPUT/OUTPUT
TERMINALS
Screws
Guide
Socket
Plug
Figure shows D-sub 15 terminal.
DVI / D-sub 15 Terminal
5-BNC / VideoTerminal
4 TERMINAL SLOTS (Factory set)
NOTES ON ORDERING OR USING
OPTIONAL INTERFACE BOARD
When ordering or using Optional Interface Board (Termi-
nal Board), contact your sales dealer. When contacting the
sales dealer, tell the Option Control Number (Op.cont.No.)
in the menu that is located on the bottom of the information
menu.(See page 28)
Note:
In the replacement of terminal board, the MAIN
ON/OFF switch should be OFF position.
Replacement of Terminal
Installation
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sanyo plc xf47 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sanyo plc xf47 in the language / languages: English as an attachment in your email.

The manual is 5,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info